WSL2-Linux-Kernel/net/ipv4/ipvs/Kconfig

245 строки
9.3 KiB
Plaintext
Исходник Обычный вид История

#
# IP Virtual Server configuration
#
menu "IP: Virtual Server Configuration"
depends on NETFILTER
config IP_VS
tristate "IP virtual server support (EXPERIMENTAL)"
depends on NETFILTER
---help---
IP Virtual Server support will let you build a high-performance
virtual server based on cluster of two or more real servers. This
option must be enabled for at least one of the clustered computers
that will take care of intercepting incoming connections to a
single IP address and scheduling them to real servers.
Three request dispatching techniques are implemented, they are
virtual server via NAT, virtual server via tunneling and virtual
server via direct routing. The several scheduling algorithms can
be used to choose which server the connection is directed to,
thus load balancing can be achieved among the servers. For more
information and its administration program, please visit the
following URL: <http://www.linuxvirtualserver.org/>.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_DEBUG
bool "IP virtual server debugging"
depends on IP_VS
---help---
Say Y here if you want to get additional messages useful in
debugging the IP virtual server code. You can change the debug
level in /proc/sys/net/ipv4/vs/debug_level
config IP_VS_TAB_BITS
int "IPVS connection table size (the Nth power of 2)"
depends on IP_VS
default "12"
---help---
The IPVS connection hash table uses the chaining scheme to handle
hash collisions. Using a big IPVS connection hash table will greatly
reduce conflicts when there are hundreds of thousands of connections
in the hash table.
Note the table size must be power of 2. The table size will be the
value of 2 to the your input number power. The number to choose is
from 8 to 20, the default number is 12, which means the table size
is 4096. Don't input the number too small, otherwise you will lose
performance on it. You can adapt the table size yourself, according
to your virtual server application. It is good to set the table size
not far less than the number of connections per second multiplying
average lasting time of connection in the table. For example, your
virtual server gets 200 connections per second, the connection lasts
for 200 seconds in average in the connection table, the table size
should be not far less than 200x200, it is good to set the table
size 32768 (2**15).
Another note that each connection occupies 128 bytes effectively and
each hash entry uses 8 bytes, so you can estimate how much memory is
needed for your box.
comment "IPVS transport protocol load balancing support"
depends on IP_VS
config IP_VS_PROTO_TCP
bool "TCP load balancing support"
depends on IP_VS
---help---
This option enables support for load balancing TCP transport
protocol. Say Y if unsure.
config IP_VS_PROTO_UDP
bool "UDP load balancing support"
depends on IP_VS
---help---
This option enables support for load balancing UDP transport
protocol. Say Y if unsure.
config IP_VS_PROTO_ESP
bool "ESP load balancing support"
depends on IP_VS
---help---
This option enables support for load balancing ESP (Encapsultion
Security Payload) transport protocol. Say Y if unsure.
config IP_VS_PROTO_AH
bool "AH load balancing support"
depends on IP_VS
---help---
This option enables support for load balancing AH (Authentication
Header) transport protocol. Say Y if unsure.
comment "IPVS scheduler"
depends on IP_VS
config IP_VS_RR
tristate "round-robin scheduling"
depends on IP_VS
---help---
The robin-robin scheduling algorithm simply directs network
connections to different real servers in a round-robin manner.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_WRR
tristate "weighted round-robin scheduling"
depends on IP_VS
---help---
The weighted robin-robin scheduling algorithm directs network
connections to different real servers based on server weights
in a round-robin manner. Servers with higher weights receive
new connections first than those with less weights, and servers
with higher weights get more connections than those with less
weights and servers with equal weights get equal connections.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_LC
tristate "least-connection scheduling"
depends on IP_VS
---help---
The least-connection scheduling algorithm directs network
connections to the server with the least number of active
connections.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_WLC
tristate "weighted least-connection scheduling"
depends on IP_VS
---help---
The weighted least-connection scheduling algorithm directs network
connections to the server with the least active connections
normalized by the server weight.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_LBLC
tristate "locality-based least-connection scheduling"
depends on IP_VS
---help---
The locality-based least-connection scheduling algorithm is for
destination IP load balancing. It is usually used in cache cluster.
This algorithm usually directs packet destined for an IP address to
its server if the server is alive and under load. If the server is
overloaded (its active connection numbers is larger than its weight)
and there is a server in its half load, then allocate the weighted
least-connection server to this IP address.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_LBLCR
tristate "locality-based least-connection with replication scheduling"
depends on IP_VS
---help---
The locality-based least-connection with replication scheduling
algorithm is also for destination IP load balancing. It is
usually used in cache cluster. It differs from the LBLC scheduling
as follows: the load balancer maintains mappings from a target
to a set of server nodes that can serve the target. Requests for
a target are assigned to the least-connection node in the target's
server set. If all the node in the server set are over loaded,
it picks up a least-connection node in the cluster and adds it
in the sever set for the target. If the server set has not been
modified for the specified time, the most loaded node is removed
from the server set, in order to avoid high degree of replication.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_DH
tristate "destination hashing scheduling"
depends on IP_VS
---help---
The destination hashing scheduling algorithm assigns network
connections to the servers through looking up a statically assigned
hash table by their destination IP addresses.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_SH
tristate "source hashing scheduling"
depends on IP_VS
---help---
The source hashing scheduling algorithm assigns network
connections to the servers through looking up a statically assigned
hash table by their source IP addresses.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_SED
tristate "shortest expected delay scheduling"
depends on IP_VS
---help---
The shortest expected delay scheduling algorithm assigns network
connections to the server with the shortest expected delay. The
expected delay that the job will experience is (Ci + 1) / Ui if
sent to the ith server, in which Ci is the number of connections
on the the ith server and Ui is the fixed service rate (weight)
of the ith server.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
config IP_VS_NQ
tristate "never queue scheduling"
depends on IP_VS
---help---
The never queue scheduling algorithm adopts a two-speed model.
When there is an idle server available, the job will be sent to
the idle server, instead of waiting for a fast one. When there
is no idle server available, the job will be sent to the server
that minimize its expected delay (The Shortest Expected Delay
scheduling algorithm).
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
comment 'IPVS application helper'
depends on IP_VS
config IP_VS_FTP
tristate "FTP protocol helper"
depends on IP_VS && IP_VS_PROTO_TCP
---help---
FTP is a protocol that transfers IP address and/or port number in
the payload. In the virtual server via Network Address Translation,
the IP address and port number of real servers cannot be sent to
clients in ftp connections directly, so FTP protocol helper is
required for tracking the connection and mangling it back to that of
virtual service.
If you want to compile it in kernel, say Y. To compile it as a
module, choose M here. If unsure, say N.
endmenu