WSL2-Linux-Kernel/Documentation/virt/kvm/locking.rst

.. SPDX-License-Identifier: GPL-2.0

=================
KVM Lock Overview
=================

1. Acquisition Orders
---------------------

The acquisition orders for mutexes are as follows:

- kvm->lock is taken outside vcpu->mutex

- kvm->lock is taken outside kvm->slots_lock and kvm->irq_lock

- kvm->slots_lock is taken outside kvm->irq_lock, though acquiring
  them together is quite rare.

On x86:

- vcpu->mutex is taken outside kvm->arch.hyperv.hv_lock

- kvm->arch.mmu_lock is an rwlock.  kvm->arch.tdp_mmu_pages_lock is
  taken inside kvm->arch.mmu_lock, and cannot be taken without already
  holding kvm->arch.mmu_lock (typically with ``read_lock``, otherwise
  there's no need to take kvm->arch.tdp_mmu_pages_lock at all).

Everything else is a leaf: no other lock is taken inside the critical
sections.

2. Exception
------------

Fast page fault:

Fast page fault is the fast path which fixes the guest page fault out of
the mmu-lock on x86. Currently, the page fault can be fast in one of the
following two cases:

1. Access Tracking: The SPTE is not present, but it is marked for access
   tracking i.e. the SPTE_SPECIAL_MASK is set. That means we need to
   restore the saved R/X bits. This is described in more detail later below.

2. Write-Protection: The SPTE is present and the fault is
   caused by write-protect. That means we just need to change the W bit of
   the spte.

What we use to avoid all the race is the SPTE_HOST_WRITEABLE bit and
SPTE_MMU_WRITEABLE bit on the spte:

- SPTE_HOST_WRITEABLE means the gfn is writable on host.
- SPTE_MMU_WRITEABLE means the gfn is writable on mmu. The bit is set when
  the gfn is writable on guest mmu and it is not write-protected by shadow
  page write-protection.

On fast page fault path, we will use cmpxchg to atomically set the spte W
bit if spte.SPTE_HOST_WRITEABLE = 1 and spte.SPTE_WRITE_PROTECT = 1, or
restore the saved R/X bits if VMX_EPT_TRACK_ACCESS mask is set, or both. This
is safe because whenever changing these bits can be detected by cmpxchg.

But we need carefully check these cases:

1) The mapping from gfn to pfn

The mapping from gfn to pfn may be changed since we can only ensure the pfn
is not changed during cmpxchg. This is a ABA problem, for example, below case
will happen:

+------------------------------------------------------------------------+
| At the beginning::                                                     |
|                                                                        |
|	gpte = gfn1                                                      |
|	gfn1 is mapped to pfn1 on host                                   |
|	spte is the shadow page table entry corresponding with gpte and  |
|	spte = pfn1                                                      |
+------------------------------------------------------------------------+
| On fast page fault path:                                               |
+------------------------------------+-----------------------------------+
| CPU 0:                             | CPU 1:                            |
+------------------------------------+-----------------------------------+
| ::                                 |                                   |
|                                    |                                   |
|   old_spte = *spte;                |                                   |
+------------------------------------+-----------------------------------+
|                                    | pfn1 is swapped out::             |
|                                    |                                   |
|                                    |    spte = 0;                      |
|                                    |                                   |
|                                    | pfn1 is re-alloced for gfn2.      |
|                                    |                                   |
|                                    | gpte is changed to point to       |
|                                    | gfn2 by the guest::               |
|                                    |                                   |
|                                    |    spte = pfn1;                   |
+------------------------------------+-----------------------------------+
| ::                                                                     |
|                                                                        |
|   if (cmpxchg(spte, old_spte, old_spte+W)                              |
|	mark_page_dirty(vcpu->kvm, gfn1)                                 |
|            OOPS!!!                                                     |
+------------------------------------------------------------------------+

We dirty-log for gfn1, that means gfn2 is lost in dirty-bitmap.

For direct sp, we can easily avoid it since the spte of direct sp is fixed
to gfn.  For indirect sp, we disabled fast page fault for simplicity.

A solution for indirect sp could be to pin the gfn, for example via
kvm_vcpu_gfn_to_pfn_atomic, before the cmpxchg.  After the pinning:

- We have held the refcount of pfn that means the pfn can not be freed and
  be reused for another gfn.
- The pfn is writable and therefore it cannot be shared between different gfns
  by KSM.

Then, we can ensure the dirty bitmaps is correctly set for a gfn.

2) Dirty bit tracking

In the origin code, the spte can be fast updated (non-atomically) if the
spte is read-only and the Accessed bit has already been set since the
Accessed bit and Dirty bit can not be lost.

But it is not true after fast page fault since the spte can be marked
writable between reading spte and updating spte. Like below case:

+------------------------------------------------------------------------+
| At the beginning::                                                     |
|                                                                        |
|	spte.W = 0                                                       |
|	spte.Accessed = 1                                                |
+------------------------------------+-----------------------------------+
| CPU 0:                             | CPU 1:                            |
+------------------------------------+-----------------------------------+
| In mmu_spte_clear_track_bits()::   |                                   |
|                                    |                                   |
|  old_spte = *spte;                 |                                   |
|                                    |                                   |
|                                    |                                   |
|  /* 'if' condition is satisfied. */|                                   |
|  if (old_spte.Accessed == 1 &&     |                                   |
|       old_spte.W == 0)             |                                   |
|     spte = 0ull;                   |                                   |
+------------------------------------+-----------------------------------+
|                                    | on fast page fault path::         |
|                                    |                                   |
|                                    |    spte.W = 1                     |
|                                    |                                   |
|                                    | memory write on the spte::        |
|                                    |                                   |
|                                    |    spte.Dirty = 1                 |
+------------------------------------+-----------------------------------+
|  ::                                |                                   |
|                                    |                                   |
|   else                             |                                   |
|     old_spte = xchg(spte, 0ull)    |                                   |
|   if (old_spte.Accessed == 1)      |                                   |
|     kvm_set_pfn_accessed(spte.pfn);|                                   |
|   if (old_spte.Dirty == 1)         |                                   |
|     kvm_set_pfn_dirty(spte.pfn);   |                                   |
|     OOPS!!!                        |                                   |
+------------------------------------+-----------------------------------+

The Dirty bit is lost in this case.

In order to avoid this kind of issue, we always treat the spte as "volatile"
if it can be updated out of mmu-lock, see spte_has_volatile_bits(), it means,
the spte is always atomically updated in this case.

3) flush tlbs due to spte updated

If the spte is updated from writable to readonly, we should flush all TLBs,
otherwise rmap_write_protect will find a read-only spte, even though the
writable spte might be cached on a CPU's TLB.

As mentioned before, the spte can be updated to writable out of mmu-lock on
fast page fault path, in order to easily audit the path, we see if TLBs need
be flushed caused by this reason in mmu_spte_update() since this is a common
function to update spte (present -> present).

Since the spte is "volatile" if it can be updated out of mmu-lock, we always
atomically update the spte, the race caused by fast page fault can be avoided,
See the comments in spte_has_volatile_bits() and mmu_spte_update().

Lockless Access Tracking:

This is used for Intel CPUs that are using EPT but do not support the EPT A/D
bits. In this case, when the KVM MMU notifier is called to track accesses to a
page (via kvm_mmu_notifier_clear_flush_young), it marks the PTE as not-present
by clearing the RWX bits in the PTE and storing the original R & X bits in
some unused/ignored bits. In addition, the SPTE_SPECIAL_MASK is also set on the
PTE (using the ignored bit 62). When the VM tries to access the page later on,
a fault is generated and the fast page fault mechanism described above is used
to atomically restore the PTE to a Present state. The W bit is not saved when
the PTE is marked for access tracking and during restoration to the Present
state, the W bit is set depending on whether or not it was a write access. If
it wasn't, then the W bit will remain clear until a write access happens, at
which time it will be set using the Dirty tracking mechanism described above.

3. Reference
------------

:Name:		kvm_lock
:Type:		mutex
:Arch:		any
:Protects:	- vm_list

:Name:		kvm_count_lock
:Type:		raw_spinlock_t
:Arch:		any
:Protects:	- hardware virtualization enable/disable
:Comment:	'raw' because hardware enabling/disabling must be atomic /wrt
		migration.

:Name:		kvm_arch::tsc_write_lock
:Type:		raw_spinlock
:Arch:		x86
:Protects:	- kvm_arch::{last_tsc_write,last_tsc_nsec,last_tsc_offset}
		- tsc offset in vmcb
:Comment:	'raw' because updating the tsc offsets must not be preempted.

:Name:		kvm->mmu_lock
:Type:		spinlock_t
:Arch:		any
:Protects:	-shadow page/shadow tlb entry
:Comment:	it is a spinlock since it is used in mmu notifier.

:Name:		kvm->srcu
:Type:		srcu lock
:Arch:		any
:Protects:	- kvm->memslots
		- kvm->buses
:Comment:	The srcu read lock must be held while accessing memslots (e.g.
		when using gfn_to_* functions) and while accessing in-kernel
		MMIO/PIO address->device structure mapping (kvm->buses).
		The srcu index can be stored in kvm_vcpu->srcu_idx per vcpu
		if it is needed by multiple functions.

:Name:		blocked_vcpu_on_cpu_lock
:Type:		spinlock_t
:Arch:		x86
:Protects:	blocked_vcpu_on_cpu
:Comment:	This is a per-CPU lock and it is used for VT-d posted-interrupts.
		When VT-d posted-interrupts is supported and the VM has assigned
		devices, we put the blocked vCPU on the list blocked_vcpu_on_cpu
		protected by blocked_vcpu_on_cpu_lock, when VT-d hardware issues
		wakeup notification event since external interrupts from the
		assigned devices happens, we will find the vCPU on the list to
		wakeup.