WSL2-Linux-Kernel/drivers/nvmem/Makefile

#
# Makefile for nvmem drivers.
#

obj-$(CONFIG_NVMEM)		+= nvmem_core.o
nvmem_core-y			:= core.o

# Devices
obj-$(CONFIG_QCOM_QFPROM)	+= nvmem_qfprom.o
nvmem_qfprom-y			:= qfprom.o
nvmem: Add a simple NVMEM framework for nvmem providers This patch adds just providers part of the framework just to enable easy review. Up until now, NVMEM drivers like eeprom were stored in drivers/misc, where they all had to duplicate pretty much the same code to register a sysfs file, allow in-kernel users to access the content of the devices they were driving, etc. This was also a problem as far as other in-kernel users were involved, since the solutions used were pretty much different from on driver to another, there was a rather big abstraction leak. This introduction of this framework aims at solving this. It also introduces DT representation for consumer devices to go get the data they require (MAC Addresses, SoC/Revision ID, part numbers, and so on) from the nvmems. Having regmap interface to this framework would give much better abstraction for nvmems on different buses. Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> [Maxime Ripard: intial version of eeprom framework] Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Tested-by: Stefan Wahren <stefan.wahren@i2se.com> Tested-by: Philipp Zabel <p.zabel@pengutronix.de> Tested-by: Rajendra Nayak <rnayak@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> 2015-07-27 14:13:19 +03:00			`#`
			`# Makefile for nvmem drivers.`
			`#`

			`obj-$(CONFIG_NVMEM) += nvmem_core.o`
			`nvmem_core-y := core.o`
nvmem: qfprom: Add Qualcomm QFPROM support. This patch adds QFPROM support driver which is used by other drivers like thermal sensor and cpufreq. On MSM parts there are some efuses (called qfprom) these fuses store things like calibration data, speed bins.. etc. Drivers like cpufreq, thermal sensors would read out this data for configuring the driver. Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Reviewed-by: Stephen Boyd <sboyd@codeaurora.org> Tested-by: Philipp Zabel <p.zabel@pengutronix.de> Tested-by: Rajendra Nayak <rnayak@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> 2015-07-27 14:15:00 +03:00
			`# Devices`
			`obj-$(CONFIG_QCOM_QFPROM) += nvmem_qfprom.o`
			`nvmem_qfprom-y := qfprom.o`