m68knommu: make 5272 UART platform addressing consistent

If we make all UART addressing consistent across all ColdFire family members
then we will be able to remove the duplicated plaform data and use a single
setup for all.

So modify the ColdFire 5272 UART addressing so that:

. UARTs are numbered from 0 up
. base addresses are absolute (not relative to MBAR peripheral register)

Signed-off-by: Greg Ungerer <gerg@uclinux.org>

arch/m68k/include/asm/m5272sim.h

@@ -68,8 +68,8 @@
 #define	MCFSIM_DCMR1		0x5c		/* DRAM 1 Mask reg (r/w) */
 #define	MCFSIM_DCCR1		0x63		/* DRAM 1 Control reg (r/w) */
 
-#define	MCFUART_BASE1		0x100		/* Base address of UART1 */
-#define	MCFUART_BASE2		0x140		/* Base address of UART2 */
+#define	MCFUART_BASE0		(MCF_MBAR + 0x100) /* Base address UART0 */
+#define	MCFUART_BASE1		(MCF_MBAR + 0x140) /* Base address UART1 */
 
 #define	MCFSIM_PACNT		(MCF_MBAR + 0x80) /* Port A Control (r/w) */
 #define	MCFSIM_PADDR		(MCF_MBAR + 0x84) /* Port A Direction (r/w) */
@@ -101,8 +101,8 @@
 #define	MCF_IRQ_TIMER2		70		/* Timer 2 */
 #define	MCF_IRQ_TIMER3		71		/* Timer 3 */
 #define	MCF_IRQ_TIMER4		72		/* Timer 4 */
-#define	MCF_IRQ_UART1		73		/* UART 1 */
-#define	MCF_IRQ_UART2		74		/* UART 2 */
+#define	MCF_IRQ_UART0		73		/* UART 0 */
+#define	MCF_IRQ_UART1		74		/* UART 1 */
 #define	MCF_IRQ_PLIP		75		/* PLIC 2Khz Periodic */
 #define	MCF_IRQ_PLIA		76		/* PLIC Asynchronous */
 #define	MCF_IRQ_USB0		77		/* USB Endpoint 0 */

arch/m68k/platform/5272/config.c

@@ -32,12 +32,12 @@ unsigned char ledbank = 0xff;
 
 static struct mcf_platform_uart m5272_uart_platform[] = {
 	{
-		.mapbase	= MCF_MBAR + MCFUART_BASE1,
-		.irq		= MCF_IRQ_UART1,
+		.mapbase	= MCFUART_BASE0,
+		.irq		= MCF_IRQ_UART0,
 	},
 	{
-		.mapbase 	= MCF_MBAR + MCFUART_BASE2,
-		.irq		= MCF_IRQ_UART2,
+		.mapbase 	= MCFUART_BASE1,
+		.irq		= MCF_IRQ_UART1,
 	},
 	{ },
 };