ARM: dts: NSP: Use hardware I2C for BCM958625HR

Now that the i2c-bcm-iproc driver has been fixed to permit reading more
than 63 bytes in a single transaction with commit fd01eecdf9 ("i2c:
iproc: Fix i2c master read more than 63 bytes") we no longer need to
bitbang i2c over GPIOs which was necessary before to allow the
PHYLINK/SFP subsystems to read SFP modules.

Reviewed-by: Ray Jui <ray.jui@broadcom.com>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>

arch/arm/boot/dts/bcm958625hr.dts

@@ -55,18 +55,9 @@
 		priority = <200>;
 	};
 
-	/* Hardware I2C block cannot do more than 63 bytes per transfer,
-	 * which would prevent reading from a SFP's EEPROM (256 byte).
-	 */
-	i2c1: i2c {
-		compatible = "i2c-gpio";
-		sda-gpios = <&gpioa 5 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
-		scl-gpios = <&gpioa 4 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
-	};
-
 	sfp: sfp {
 		compatible = "sff,sfp";
-		i2c-bus = <&i2c1>;
+		i2c-bus = <&i2c0>;
 		mod-def0-gpios = <&gpioa 28 GPIO_ACTIVE_LOW>;
 		los-gpios = <&gpioa 24 GPIO_ACTIVE_HIGH>;
 		tx-fault-gpios = <&gpioa 30 GPIO_ACTIVE_HIGH>;
@@ -74,6 +65,10 @@
 	};
 };
 
+&i2c0 {
+	status = "okay";
+};
+
 &amac0 {
 	status = "okay";
 };