arm64: dts: NS2: add support for XMC form factor
The BCM958712DxXMC board is a smaller form factor typically used as controller boards for switches. This smaller board has less devices pinned out, so only a few need be populated in the device tree. Signed-off-by: Jon Mason <jon.mason@broadcom.com> Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
This commit is contained in:
Родитель
0cc878d678
Коммит
096fe8726e
|
@ -1,5 +1,5 @@
|
||||||
dtb-$(CONFIG_ARCH_BCM2835) += bcm2837-rpi-3-b.dtb
|
dtb-$(CONFIG_ARCH_BCM2835) += bcm2837-rpi-3-b.dtb
|
||||||
dtb-$(CONFIG_ARCH_BCM_IPROC) += ns2-svk.dtb
|
dtb-$(CONFIG_ARCH_BCM_IPROC) += ns2-svk.dtb ns2-xmc.dtb
|
||||||
dtb-$(CONFIG_ARCH_VULCAN) += vulcan-eval.dtb
|
dtb-$(CONFIG_ARCH_VULCAN) += vulcan-eval.dtb
|
||||||
|
|
||||||
always := $(dtb-y)
|
always := $(dtb-y)
|
||||||
|
|
|
@ -0,0 +1,191 @@
|
||||||
|
/*
|
||||||
|
* BSD LICENSE
|
||||||
|
*
|
||||||
|
* Copyright(c) 2016 Broadcom. All rights reserved.
|
||||||
|
*
|
||||||
|
* Redistribution and use in source and binary forms, with or without
|
||||||
|
* modification, are permitted provided that the following conditions
|
||||||
|
* are met:
|
||||||
|
*
|
||||||
|
* * Redistributions of source code must retain the above copyright
|
||||||
|
* notice, this list of conditions and the following disclaimer.
|
||||||
|
* * Redistributions in binary form must reproduce the above copyright
|
||||||
|
* notice, this list of conditions and the following disclaimer in
|
||||||
|
* the documentation and/or other materials provided with the
|
||||||
|
* distribution.
|
||||||
|
* * Neither the name of Broadcom Corporation nor the names of its
|
||||||
|
* contributors may be used to endorse or promote products derived
|
||||||
|
* from this software without specific prior written permission.
|
||||||
|
*
|
||||||
|
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
||||||
|
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
||||||
|
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
|
||||||
|
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
|
||||||
|
* OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
|
||||||
|
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
|
||||||
|
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
|
||||||
|
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
|
||||||
|
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
|
||||||
|
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
|
||||||
|
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
|
||||||
|
*/
|
||||||
|
|
||||||
|
/dts-v1/;
|
||||||
|
|
||||||
|
#include "ns2.dtsi"
|
||||||
|
|
||||||
|
/ {
|
||||||
|
model = "Broadcom NS2 XMC";
|
||||||
|
compatible = "brcm,ns2-xmc", "brcm,ns2";
|
||||||
|
|
||||||
|
aliases {
|
||||||
|
serial0 = &uart3;
|
||||||
|
};
|
||||||
|
|
||||||
|
chosen {
|
||||||
|
stdout-path = "serial0:115200n8";
|
||||||
|
bootargs = "earlycon=uart8250,mmio32,0x66130000";
|
||||||
|
};
|
||||||
|
|
||||||
|
memory {
|
||||||
|
device_type = "memory";
|
||||||
|
reg = <0x000000000 0x80000000 0x00000001 0x00000000>;
|
||||||
|
};
|
||||||
|
};
|
||||||
|
|
||||||
|
&enet {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&i2c0 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&i2c1 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&mdio_mux_iproc {
|
||||||
|
mdio@10 {
|
||||||
|
gphy0: eth-phy@10 {
|
||||||
|
reg = <0x10>;
|
||||||
|
};
|
||||||
|
};
|
||||||
|
};
|
||||||
|
|
||||||
|
&nand {
|
||||||
|
nandcs@0 {
|
||||||
|
compatible = "brcm,nandcs";
|
||||||
|
reg = <0>;
|
||||||
|
nand-ecc-mode = "hw";
|
||||||
|
nand-ecc-strength = <8>;
|
||||||
|
nand-ecc-step-size = <512>;
|
||||||
|
nand-bus-width = <16>;
|
||||||
|
brcm,nand-oob-sector-size = <16>;
|
||||||
|
#address-cells = <1>;
|
||||||
|
#size-cells = <1>;
|
||||||
|
|
||||||
|
partition@0 {
|
||||||
|
label = "nboot";
|
||||||
|
reg = <0x00000000 0x00280000>; /* 2.5MB */
|
||||||
|
read-only;
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@280000 {
|
||||||
|
label = "nenv";
|
||||||
|
reg = <0x00280000 0x00040000>; /* 0.25MB */
|
||||||
|
read-only;
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@2c0000 {
|
||||||
|
label = "ndtb";
|
||||||
|
reg = <0x002c0000 0x00040000>; /* 0.25MB */
|
||||||
|
read-only;
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@300000 {
|
||||||
|
label = "nsystem";
|
||||||
|
reg = <0x00300000 0x03d00000>; /* 61MB */
|
||||||
|
read-only;
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@4000000 {
|
||||||
|
label = "nrootfs";
|
||||||
|
reg = <0x04000000 0x06400000>; /* 100MB */
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@0a400000{
|
||||||
|
label = "ncustfs";
|
||||||
|
reg = <0x0a400000 0x35c00000>; /* 860MB */
|
||||||
|
};
|
||||||
|
};
|
||||||
|
};
|
||||||
|
|
||||||
|
&pci_phy0 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&pcie0 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&pcie8 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&sata_phy0 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&sata_phy1 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&sata {
|
||||||
|
status = "ok";
|
||||||
|
};
|
||||||
|
|
||||||
|
&qspi {
|
||||||
|
flash: m25p80@0 {
|
||||||
|
#address-cells = <1>;
|
||||||
|
#size-cells = <1>;
|
||||||
|
compatible = "m25p80";
|
||||||
|
spi-max-frequency = <62500000>;
|
||||||
|
m25p,default-addr-width = <3>;
|
||||||
|
reg = <0x0 0x0>;
|
||||||
|
|
||||||
|
partition@0 {
|
||||||
|
label = "bl0";
|
||||||
|
reg = <0x00000000 0x00080000>; /* 512KB */
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@80000 {
|
||||||
|
label = "fip";
|
||||||
|
reg = <0x00080000 0x00150000>; /* 1344KB */
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@1e0000 {
|
||||||
|
label = "env";
|
||||||
|
reg = <0x001e0000 0x00010000>;/* 64KB */
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@1f0000 {
|
||||||
|
label = "dtb";
|
||||||
|
reg = <0x001f0000 0x00010000>; /* 64KB */
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@200000 {
|
||||||
|
label = "kernel";
|
||||||
|
reg = <0x00200000 0x00e00000>; /* 14MB */
|
||||||
|
};
|
||||||
|
|
||||||
|
partition@1000000 {
|
||||||
|
label = "rootfs";
|
||||||
|
reg = <0x01000000 0x01000000>; /* 16MB */
|
||||||
|
};
|
||||||
|
};
|
||||||
|
};
|
||||||
|
|
||||||
|
&uart3 {
|
||||||
|
status = "ok";
|
||||||
|
};
|
Загрузка…
Ссылка в новой задаче