PM / devfreq: tegra30: Use kHz units uniformly in the code

Part of the code uses Hz units and the other kHz, let's switch to kHz
everywhere for consistency. A small benefit from this change (besides
code's cleanup) is that now powertop utility correctly displays devfreq's
stats, for some reason it expects them to be in kHz.

Tested-by: Peter Geis <pgwipeout@gmail.com>
Reviewed-by: Chanwoo Choi <cw00.choi@samsung.com>
Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>

drivers/devfreq/tegra30-devfreq.c

@@ -448,7 +448,7 @@ static int tegra_devfreq_target(struct device *dev, unsigned long *freq,
 	rate = dev_pm_opp_get_freq(opp);
 	dev_pm_opp_put(opp);
 
-	err = clk_set_min_rate(tegra->emc_clock, rate);
+	err = clk_set_min_rate(tegra->emc_clock, rate * KHZ);
 	if (err)
 		return err;
 
@@ -477,7 +477,7 @@ static int tegra_devfreq_get_dev_status(struct device *dev,
 	stat->private_data = tegra;
 
 	/* The below are to be used by the other governors */
-	stat->current_frequency = cur_freq * KHZ;
+	stat->current_frequency = cur_freq;
 
 	actmon_dev = &tegra->devices[MCALL];
 
@@ -527,7 +527,7 @@ static int tegra_governor_get_target(struct devfreq *devfreq,
 		target_freq = max(target_freq, dev->target_freq);
 	}
 
-	*freq = target_freq * KHZ;
+	*freq = target_freq;
 
 	return 0;
 }
@@ -663,7 +663,7 @@ static int tegra_devfreq_probe(struct platform_device *pdev)
 			goto remove_opps;
 		}
 
-		err = dev_pm_opp_add(&pdev->dev, rate, 0);
+		err = dev_pm_opp_add(&pdev->dev, rate / KHZ, 0);
 		if (err) {
 			dev_err(&pdev->dev, "Failed to add OPP: %d\n", err);
 			goto remove_opps;
@@ -686,7 +686,8 @@ static int tegra_devfreq_probe(struct platform_device *pdev)
 		goto unreg_notifier;
 	}
 
-	tegra_devfreq_profile.initial_freq = clk_get_rate(tegra->emc_clock);
+	tegra_devfreq_profile.initial_freq = tegra->cur_freq;
+
 	devfreq = devfreq_add_device(&pdev->dev, &tegra_devfreq_profile,
 				     "tegra_actmon", NULL);
 	if (IS_ERR(devfreq)) {