ARM: dts: dra76-evm: Add pinctrl data for higher speed MMC/SD modes
The SD card interface on DRA76x EVM can support high speed SD cards. The eMMC onboard can support upto HS200 mode. Enable support for these higher speed modes in the device-tree file. Signed-off-by: Sekhar Nori <nsekhar@ti.com> Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
This commit is contained in:
Родитель
d48bea5732
Коммит
0ec76a63e5
|
@ -314,16 +314,20 @@
|
|||
* is always hardwired.
|
||||
*/
|
||||
cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>;
|
||||
pinctrl-names = "default";
|
||||
pinctrl-names = "default", "hs";
|
||||
pinctrl-0 = <&mmc1_pins_default>;
|
||||
pinctrl-1 = <&mmc1_pins_hs>;
|
||||
};
|
||||
|
||||
&mmc2 {
|
||||
status = "okay";
|
||||
vmmc-supply = <&vio_1v8>;
|
||||
bus-width = <8>;
|
||||
pinctrl-names = "default";
|
||||
pinctrl-names = "default", "hs", "ddr_1_8v", "hs200_1_8v";
|
||||
pinctrl-0 = <&mmc2_pins_default>;
|
||||
pinctrl-1 = <&mmc2_pins_default>;
|
||||
pinctrl-2 = <&mmc2_pins_default>;
|
||||
pinctrl-3 = <&mmc2_pins_hs200 &mmc2_iodelay_hs200_conf>;
|
||||
};
|
||||
|
||||
/* No RTC on this device */
|
||||
|
|
Загрузка…
Ссылка в новой задаче