mac80211: adding 802.11n HT framework definitions
New structures: - ieee80211_ht_info: describing STA's HT capabilities - ieee80211_ht_bss_info: describing BSS's HT characteristics Changed structures: - ieee80211_hw_mode: now also holds PHY HT capabilities for each HW mode - ieee80211_conf: ht_conf holds current self HT configuration ht_bss_conf holds current BSS HT configuration - flag IEEE80211_CONF_SUPPORT_HT_MODE added to indicate if HT use is desired - sta_info: now also holds Peer's HT capabilities Signed-off-by: Ron Rindjunsky <ron.rindjunsky@intel.com> Signed-off-by: John W. Linville <linville@tuxdriver.com> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Родитель
82b3cad942
Коммит
10816d40f2
|
@ -138,18 +138,55 @@ enum ieee80211_phymode {
|
|||
NUM_IEEE80211_MODES
|
||||
};
|
||||
|
||||
/**
|
||||
* struct ieee80211_ht_info - describing STA's HT capabilities
|
||||
*
|
||||
* This structure describes most essential parameters needed
|
||||
* to describe 802.11n HT capabilities for an STA.
|
||||
*
|
||||
* @ht_supported: is HT supported by STA, 0: no, 1: yes
|
||||
* @cap: HT capabilities map as described in 802.11n spec
|
||||
* @ampdu_factor: Maximum A-MPDU length factor
|
||||
* @ampdu_density: Minimum A-MPDU spacing
|
||||
* @supp_mcs_set: Supported MCS set as described in 802.11n spec
|
||||
*/
|
||||
struct ieee80211_ht_info {
|
||||
u8 ht_supported;
|
||||
u16 cap; /* use IEEE80211_HT_CAP_ */
|
||||
u8 ampdu_factor;
|
||||
u8 ampdu_density;
|
||||
u8 supp_mcs_set[16];
|
||||
};
|
||||
|
||||
/**
|
||||
* struct ieee80211_ht_bss_info - describing BSS's HT characteristics
|
||||
*
|
||||
* This structure describes most essential parameters needed
|
||||
* to describe 802.11n HT characteristics in a BSS
|
||||
*
|
||||
* @primary_channel: channel number of primery channel
|
||||
* @bss_cap: 802.11n's general BSS capabilities (e.g. channel width)
|
||||
* @bss_op_mode: 802.11n's BSS operation modes (e.g. HT protection)
|
||||
*/
|
||||
struct ieee80211_ht_bss_info {
|
||||
u8 primary_channel;
|
||||
u8 bss_cap; /* use IEEE80211_HT_IE_CHA_ */
|
||||
u8 bss_op_mode; /* use IEEE80211_HT_IE_ */
|
||||
};
|
||||
|
||||
/**
|
||||
* struct ieee80211_hw_mode - PHY mode definition
|
||||
*
|
||||
* This structure describes the capabilities supported by the device
|
||||
* in a single PHY mode.
|
||||
*
|
||||
* @list: internal
|
||||
* @channels: pointer to array of supported channels
|
||||
* @rates: pointer to array of supported bitrates
|
||||
* @mode: the PHY mode for this definition
|
||||
* @num_channels: number of supported channels
|
||||
* @channels: pointer to array of supported channels
|
||||
* @num_rates: number of supported bitrates
|
||||
* @rates: pointer to array of supported bitrates
|
||||
* @list: internal
|
||||
* @ht_info: PHY's 802.11n HT abilities for this mode
|
||||
*/
|
||||
struct ieee80211_hw_mode {
|
||||
struct list_head list;
|
||||
|
@ -158,6 +195,7 @@ struct ieee80211_hw_mode {
|
|||
enum ieee80211_phymode mode;
|
||||
int num_channels;
|
||||
int num_rates;
|
||||
struct ieee80211_ht_info ht_info;
|
||||
};
|
||||
|
||||
/**
|
||||
|
@ -406,11 +444,12 @@ struct ieee80211_tx_status {
|
|||
*
|
||||
* @IEEE80211_CONF_SHORT_SLOT_TIME: use 802.11g short slot time
|
||||
* @IEEE80211_CONF_RADIOTAP: add radiotap header at receive time (if supported)
|
||||
*
|
||||
* @IEEE80211_CONF_SUPPORT_HT_MODE: use 802.11n HT capabilities (if supported)
|
||||
*/
|
||||
enum ieee80211_conf_flags {
|
||||
IEEE80211_CONF_SHORT_SLOT_TIME = 1<<0,
|
||||
IEEE80211_CONF_RADIOTAP = 1<<1,
|
||||
IEEE80211_CONF_SHORT_SLOT_TIME = (1<<0),
|
||||
IEEE80211_CONF_RADIOTAP = (1<<1),
|
||||
IEEE80211_CONF_SUPPORT_HT_MODE = (1<<2),
|
||||
};
|
||||
|
||||
/**
|
||||
|
@ -434,6 +473,8 @@ enum ieee80211_conf_flags {
|
|||
* @antenna_sel_tx: transmit antenna selection, 0: default/diversity,
|
||||
* 1/2: antenna 0/1
|
||||
* @antenna_sel_rx: receive antenna selection, like @antenna_sel_tx
|
||||
* @ht_conf: describes current self configuration of 802.11n HT capabilies
|
||||
* @ht_bss_conf: describes current BSS configuration of 802.11n HT parameters
|
||||
*/
|
||||
struct ieee80211_conf {
|
||||
int channel; /* IEEE 802.11 channel number */
|
||||
|
@ -452,6 +493,9 @@ struct ieee80211_conf {
|
|||
u8 antenna_max;
|
||||
u8 antenna_sel_tx;
|
||||
u8 antenna_sel_rx;
|
||||
|
||||
struct ieee80211_ht_info ht_conf;
|
||||
struct ieee80211_ht_bss_info ht_bss_conf;
|
||||
};
|
||||
|
||||
/**
|
||||
|
|
|
@ -99,6 +99,9 @@ struct sta_info {
|
|||
|
||||
u16 listen_interval;
|
||||
|
||||
struct ieee80211_ht_info ht_info; /* 802.11n HT capabilities
|
||||
of this STA */
|
||||
|
||||
#ifdef CONFIG_MAC80211_DEBUGFS
|
||||
struct sta_info_debugfsdentries {
|
||||
struct dentry *dir;
|
||||
|
|
Загрузка…
Ссылка в новой задаче