usb: dwc3: fix the glue drivers using the nop phy

The reset_gpio member of the usb_phy_gen_xceiv_platform_data
structure needs the have negative value or phy-generic's
probe will fail unless DT is used. 0 is a valid gpio number.

This fixes an issue where phy-generic fails to probe with
message: "usb_phy_gen_xceiv.0: Error requesting RESET GPIO 0".

Cc: <stable@vger.kernel.org>
Signed-off-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>

drivers/usb/dwc3/dwc3-exynos.c

@@ -50,6 +50,7 @@ static int dwc3_exynos_register_phys(struct dwc3_exynos *exynos)
 
 	exynos->usb2_phy = pdev;
 	pdata.type = USB_PHY_TYPE_USB2;
+	pdata.gpio_reset = -1;
 
 	ret = platform_device_add_data(exynos->usb2_phy, &pdata, sizeof(pdata));
 	if (ret)

drivers/usb/dwc3/dwc3-pci.c

@@ -52,6 +52,7 @@ static int dwc3_pci_register_phys(struct dwc3_pci *glue)
 
 	glue->usb2_phy = pdev;
 	pdata.type = USB_PHY_TYPE_USB2;
+	pdata.gpio_reset = -1;
 
 	ret = platform_device_add_data(glue->usb2_phy, &pdata, sizeof(pdata));
 	if (ret)