From 163bfb0cb1f6fbf961cf912cbde57399ea1ae0e8 Mon Sep 17 00:00:00 2001 From: Krzysztof Kozlowski Date: Thu, 9 Mar 2023 16:49:46 +0100 Subject: [PATCH] pinctrl: qcom: lpass-lpi: set output value before enabling output As per Hardware Programming Guide, when configuring pin as output, set the pin value before setting output-enable (OE). Similar approach is in main SoC TLMM pin controller. Cc: Fixes: 6e261d1090d6 ("pinctrl: qcom: Add sm8250 lpass lpi pinctrl driver") Signed-off-by: Krzysztof Kozlowski Reviewed-by: Konrad Dybcio Link: https://lore.kernel.org/r/20230309154949.658380-1-krzysztof.kozlowski@linaro.org Signed-off-by: Linus Walleij --- drivers/pinctrl/qcom/pinctrl-lpass-lpi.c | 14 +++++++++----- 1 file changed, 9 insertions(+), 5 deletions(-) diff --git a/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c b/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c index 87920257bb73..27fc8b671954 100644 --- a/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c +++ b/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c @@ -221,6 +221,15 @@ static int lpi_config_set(struct pinctrl_dev *pctldev, unsigned int group, } } + /* + * As per Hardware Programming Guide, when configuring pin as output, + * set the pin value before setting output-enable (OE). + */ + if (output_enabled) { + val = u32_encode_bits(value ? 1 : 0, LPI_GPIO_VALUE_OUT_MASK); + lpi_gpio_write(pctrl, group, LPI_GPIO_VALUE_REG, val); + } + val = lpi_gpio_read(pctrl, group, LPI_GPIO_CFG_REG); u32p_replace_bits(&val, pullup, LPI_GPIO_PULL_MASK); @@ -230,11 +239,6 @@ static int lpi_config_set(struct pinctrl_dev *pctldev, unsigned int group, lpi_gpio_write(pctrl, group, LPI_GPIO_CFG_REG, val); - if (output_enabled) { - val = u32_encode_bits(value ? 1 : 0, LPI_GPIO_VALUE_OUT_MASK); - lpi_gpio_write(pctrl, group, LPI_GPIO_VALUE_REG, val); - } - return 0; }