enic: set skb->hash type properly

Driver sets the skb l4/l3 hash based on NIC_CFG_RSS_HASH_TYPE_*,
which is bit mask. This is wrong. Hw actually provides us enum.
Use CQ_ENET_RQ_DESC_RSS_TYPE_* to set l3 and l4 hash type.

Fixes: bf751ba802 ("driver/net: enic: record q_number and rss_hash for skb")
Signed-off-by: Govindarajulu Varadarajan <_govind@gmx.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/cisco/enic/enic.h

@@ -33,7 +33,7 @@
 
 #define DRV_NAME		"enic"
 #define DRV_DESCRIPTION		"Cisco VIC Ethernet NIC Driver"
-#define DRV_VERSION		"2.3.0.20"
+#define DRV_VERSION		"2.3.0.31"
 #define DRV_COPYRIGHT		"Copyright 2008-2013 Cisco Systems, Inc"
 
 #define ENIC_BARS_MAX		6

drivers/net/ethernet/cisco/enic/enic_main.c

@@ -1166,12 +1166,18 @@ static void enic_rq_indicate_buf(struct vnic_rq *rq,
 		skb->protocol = eth_type_trans(skb, netdev);
 		skb_record_rx_queue(skb, q_number);
 		if (netdev->features & NETIF_F_RXHASH) {
-			skb_set_hash(skb, rss_hash,
-				     (rss_type &
-				      (NIC_CFG_RSS_HASH_TYPE_TCP_IPV6_EX |
-				       NIC_CFG_RSS_HASH_TYPE_TCP_IPV6 |
-				       NIC_CFG_RSS_HASH_TYPE_TCP_IPV4)) ?
-				     PKT_HASH_TYPE_L4 : PKT_HASH_TYPE_L3);
+			switch (rss_type) {
+			case CQ_ENET_RQ_DESC_RSS_TYPE_TCP_IPv4:
+			case CQ_ENET_RQ_DESC_RSS_TYPE_TCP_IPv6:
+			case CQ_ENET_RQ_DESC_RSS_TYPE_TCP_IPv6_EX:
+				skb_set_hash(skb, rss_hash, PKT_HASH_TYPE_L4);
+				break;
+			case CQ_ENET_RQ_DESC_RSS_TYPE_IPv4:
+			case CQ_ENET_RQ_DESC_RSS_TYPE_IPv6:
+			case CQ_ENET_RQ_DESC_RSS_TYPE_IPv6_EX:
+				skb_set_hash(skb, rss_hash, PKT_HASH_TYPE_L3);
+				break;
+			}
 		}
 
 		/* Hardware does not provide whole packet checksum. It only