From 34539b442b3bc7d5bf10164750302b60b91f18a7 Mon Sep 17 00:00:00 2001 From: Tony Lindgren Date: Wed, 14 Jun 2023 10:18:23 +0300 Subject: [PATCH 1/3] bus: ti-sysc: Flush posted write on enable before reset The am335x devices started producing boot errors for resetting musb module in because of subtle timing changes: Unhandled fault: external abort on non-linefetch (0x1008) ... sysc_poll_reset_sysconfig from sysc_reset+0x109/0x12 sysc_reset from sysc_probe+0xa99/0xeb0 ... The fix is to flush posted write after enable before reset during probe. Note that some devices also need to specify the delay after enable with ti,sysc-delay-us, but this is not needed for musb on am335x based on my tests. Reported-by: kernelci.org bot Closes: https://storage.kernelci.org/next/master/next-20230614/arm/multi_v7_defconfig+CONFIG_THUMB2_KERNEL=y/gcc-10/lab-cip/baseline-beaglebone-black.html Fixes: 596e7955692b ("bus: ti-sysc: Add support for software reset") Signed-off-by: Tony Lindgren --- drivers/bus/ti-sysc.c | 2 ++ 1 file changed, 2 insertions(+) diff --git a/drivers/bus/ti-sysc.c b/drivers/bus/ti-sysc.c index 21fe9854703f..4cb23b9e06ea 100644 --- a/drivers/bus/ti-sysc.c +++ b/drivers/bus/ti-sysc.c @@ -2142,6 +2142,8 @@ static int sysc_reset(struct sysc *ddata) sysc_val = sysc_read_sysconfig(ddata); sysc_val |= sysc_mask; sysc_write(ddata, sysc_offset, sysc_val); + /* Flush posted write */ + sysc_val = sysc_read_sysconfig(ddata); } if (ddata->cfg.srst_udelay) From 623cef652768860bd5f205fb7b741be278585fba Mon Sep 17 00:00:00 2001 From: Shengyu Qu Date: Sun, 6 Aug 2023 16:50:44 +0800 Subject: [PATCH 2/3] ARM: dts: am335x-bone-common: Add GPIO PHY reset on revision C3 board This patch adds ethernet PHY reset GPIO config for Beaglebone Black series boards with revision C3. This fixes a random phy startup failure bug discussed at [1]. The GPIO pin used for reset is not used on older revisions, so it is ok to apply to all board revisions. The reset timing was discussed and tested at [2]. [1] https://forum.digikey.com/t/ethernet-device-is-not-detecting-on-ubuntu-20-04-lts-on-bbg/19948 [2] https://forum.beagleboard.org/t/recognizing-a-beaglebone-black-rev-c3-board/31249/ Signed-off-by: Robert Nelson Signed-off-by: Shengyu Qu Message-ID: Signed-off-by: Tony Lindgren --- arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi b/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi index b958607c71dc..400424b5d4dc 100644 --- a/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi +++ b/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi @@ -145,6 +145,8 @@ /* MDIO */ AM33XX_PADCONF(AM335X_PIN_MDIO, PIN_INPUT_PULLUP | SLEWCTRL_FAST, MUX_MODE0) AM33XX_PADCONF(AM335X_PIN_MDC, PIN_OUTPUT_PULLUP, MUX_MODE0) + /* Added to support GPIO controlled PHY reset */ + AM33XX_PADCONF(AM335X_PIN_UART0_CTSN, PIN_OUTPUT_PULLUP, MUX_MODE7) >; }; @@ -153,6 +155,8 @@ /* MDIO reset value */ AM33XX_PADCONF(AM335X_PIN_MDIO, PIN_INPUT_PULLDOWN, MUX_MODE7) AM33XX_PADCONF(AM335X_PIN_MDC, PIN_INPUT_PULLDOWN, MUX_MODE7) + /* Added to support GPIO controlled PHY reset */ + AM33XX_PADCONF(AM335X_PIN_UART0_CTSN, PIN_INPUT_PULLDOWN, MUX_MODE7) >; }; @@ -377,6 +381,10 @@ ethphy0: ethernet-phy@0 { reg = <0>; + /* Support GPIO reset on revision C3 boards */ + reset-gpios = <&gpio1 8 GPIO_ACTIVE_LOW>; + reset-assert-us = <300>; + reset-deassert-us = <6500>; }; }; From 7aff940ec88658f7fd21137cf515956a7deaaf54 Mon Sep 17 00:00:00 2001 From: Shengyu Qu Date: Sun, 6 Aug 2023 16:50:43 +0800 Subject: [PATCH 3/3] ARM: dts: am335x-bone-common: Add vcc-supply for on-board eeprom The on-board eeprom on beaglebone series has a power supply from VDD_3V3A, add that to dts to reduce dummy regulator warning. Signed-off-by: Shengyu Qu Message-ID: Signed-off-by: Tony Lindgren --- arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi | 1 + 1 file changed, 1 insertion(+) diff --git a/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi b/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi index 400424b5d4dc..96451c8a815c 100644 --- a/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi +++ b/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi @@ -219,6 +219,7 @@ baseboard_eeprom: baseboard_eeprom@50 { compatible = "atmel,24c256"; reg = <0x50>; + vcc-supply = <&ldo4_reg>; #address-cells = <1>; #size-cells = <1>;