ARM: dts: am33xx-l4: add dt node for new cpsw switchdev driver

Add DT node for the new cpsw switchdev based driver.

Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/boot/dts/am33xx-l4.dtsi

@@ -751,6 +751,55 @@
 					phys = <&phy_gmii_sel 2 1>;
 				};
 			};
+
+			mac_sw: switch@0 {
+				compatible = "ti,am335x-cpsw-switch", "ti,cpsw-switch";
+				reg = <0x0 0x4000>;
+				ranges = <0 0 0x4000>;
+				clocks = <&cpsw_125mhz_gclk>;
+				clock-names = "fck";
+				#address-cells = <1>;
+				#size-cells = <1>;
+				syscon = <&scm_conf>;
+				status = "disabled";
+
+				interrupts = <40 41 42 43>;
+				interrupt-names = "rx_thresh", "rx", "tx", "misc";
+
+				ethernet-ports {
+					#address-cells = <1>;
+					#size-cells = <0>;
+
+					cpsw_port1: port@1 {
+						reg = <1>;
+						label = "port1";
+						mac-address = [ 00 00 00 00 00 00 ];
+						phys = <&phy_gmii_sel 1 1>;
+					};
+
+					cpsw_port2: port@2 {
+						reg = <2>;
+						label = "port2";
+						mac-address = [ 00 00 00 00 00 00 ];
+						phys = <&phy_gmii_sel 2 1>;
+					};
+				};
+
+				davinci_mdio_sw: mdio@1000 {
+					compatible = "ti,cpsw-mdio","ti,davinci_mdio";
+					clocks = <&cpsw_125mhz_gclk>;
+					clock-names = "fck";
+					#address-cells = <1>;
+					#size-cells = <0>;
+					bus_freq = <1000000>;
+					reg = <0x1000 0x100>;
+				};
+
+				cpts {
+					clocks = <&cpsw_cpts_rft_clk>;
+					clock-names = "cpts";
+				};
+			};
 		};
 
 		target-module@180000 {			/* 0x4a180000, ap 5 10.0 */