MIPS: maltaup_xpa_defconfig: Convert to use libata PATA drivers

IDE subsystem has been deprecated since 2009 and the majority
(if not all) of Linux distributions have switched to use
libata for ATA support exclusively.  However there are still
some users (mostly old or/and embedded non-x86 systems) that
have not converted from using IDE subsystem to libata PATA
drivers.  This doesn't seem to be good thing in the long-term
for Linux as while there is less and less PATA systems left
in use:

* testing efforts are divided between two subsystems

* having duplicate drivers for same hardware confuses users

This patch converts maltaup_xpa_defconfig to use libata PATA
drivers (tc86c001 IDE host driver has no corresponding libata
driver yet so it is not converted).

Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
Cc: Paul Burton <paul.burton@imgtec.com>
Cc: Markos Chandras <markos.chandras@imgtec.com>
Cc: Steven J. Hill <Steven.Hill@imgtec.com>
Cc: linux-mips@linux-mips.org
Cc: linux-ide@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Patchwork: https://patchwork.linux-mips.org/patch/11140/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

arch/mips/configs/maltaup_xpa_defconfig

@@ -244,17 +244,12 @@ CONFIG_CDROM_PKTCDVD=m
 CONFIG_ATA_OVER_ETH=m
 CONFIG_IDE=y
 CONFIG_BLK_DEV_IDECD=y
-CONFIG_IDE_GENERIC=y
-CONFIG_BLK_DEV_GENERIC=y
-CONFIG_BLK_DEV_PIIX=y
-CONFIG_BLK_DEV_IT8213=m
 CONFIG_BLK_DEV_TC86C001=m
 CONFIG_RAID_ATTRS=m
-CONFIG_SCSI=m
-CONFIG_BLK_DEV_SD=m
+CONFIG_BLK_DEV_SD=y
 CONFIG_CHR_DEV_ST=m
 CONFIG_CHR_DEV_OSST=m
-CONFIG_BLK_DEV_SR=m
+CONFIG_BLK_DEV_SR=y
 CONFIG_BLK_DEV_SR_VENDOR=y
 CONFIG_CHR_DEV_SG=m
 CONFIG_SCSI_CONSTANTS=y
@@ -269,6 +264,13 @@ CONFIG_SCSI_AACRAID=m
 CONFIG_SCSI_AIC7XXX=m
 CONFIG_AIC7XXX_RESET_DELAY_MS=15000
 # CONFIG_AIC7XXX_DEBUG_ENABLE is not set
+CONFIG_ATA=y
+CONFIG_ATA_PIIX=y
+CONFIG_PATA_IT8213=m
+CONFIG_PATA_OLDPIIX=y
+CONFIG_PATA_MPIIX=y
+CONFIG_ATA_GENERIC=y
+CONFIG_PATA_LEGACY=y
 CONFIG_MD=y
 CONFIG_BLK_DEV_MD=m
 CONFIG_MD_LINEAR=m