sh: magicpanelr2: Update for parse_mtd_partitions() fallout.

Follows the RSK+ change for the same rationale.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

arch/sh/boards/board-magicpanelr2.c

@@ -25,9 +25,6 @@
 
 #define LAN9115_READY	(__raw_readl(0xA8000084UL) & 0x00000001UL)
 
-/* Prefer cmdline over RedBoot */
-static const char *probes[] = { "cmdlinepart", "RedBoot", NULL };
-
 /* Wait until reset finished. Timeout is 100ms. */
 static int __init ethernet_reset_finished(void)
 {
@@ -293,8 +290,6 @@ static struct platform_device heartbeat_device = {
 	.resource	= heartbeat_resources,
 };
 
-static struct mtd_partition *parsed_partitions;
-
 static struct mtd_partition mpr2_partitions[] = {
 	/* Reserved for bootloader, read-only */
 	{
@@ -318,6 +313,8 @@ static struct mtd_partition mpr2_partitions[] = {
 };
 
 static struct physmap_flash_data flash_data = {
+	.parts		= mpr2_partitions,
+	.nr_parts	= ARRAY_SIZE(mpr2_partitions),
 	.width		= 2,
 };
 
@@ -337,32 +334,6 @@ static struct platform_device flash_device = {
 	},
 };
 
-static struct mtd_info *flash_mtd;
-
-static struct map_info mpr2_flash_map = {
-	.name = "Magic Panel R2 Flash",
-	.size = 0x2000000UL,
-	.bankwidth = 2,
-};
-
-static void __init set_mtd_partitions(void)
-{
-	int nr_parts = 0;
-
-	simple_map_init(&mpr2_flash_map);
-	flash_mtd = do_map_probe("cfi_probe", &mpr2_flash_map);
-	nr_parts = parse_mtd_partitions(flash_mtd, probes,
-					&parsed_partitions, 0);
-	/* If there is no partition table, used the hard coded table */
-	if (nr_parts <= 0) {
-		flash_data.parts = mpr2_partitions;
-		flash_data.nr_parts = ARRAY_SIZE(mpr2_partitions);
-	} else {
-		flash_data.nr_parts = nr_parts;
-		flash_data.parts = parsed_partitions;
-	}
-}
-
 /*
  * Add all resources to the platform_device
  */
@@ -376,7 +347,6 @@ static struct platform_device *mpr2_devices[] __initdata = {
 
 static int __init mpr2_devices_setup(void)
 {
-	set_mtd_partitions();
 	return platform_add_devices(mpr2_devices, ARRAY_SIZE(mpr2_devices));
 }
 device_initcall(mpr2_devices_setup);