drm/ast: Properly initialize P2A base before using it in ast_init_3rdtx()

If the P2A has been used to target other SOC registers before that
call, we're going to hit the wrong place so make sure we set the
base address up properly before using it.

(P2A stands for PCIe to AHB bridge and is the bride that allows
accessing the AST's internal AHB bus using a relocatable 64k
window in the second half of the PCIe MMIO BAR)

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Dave Airlie <airlied@redhat.com>
This commit is contained in:
Benjamin Herrenschmidt 2014-09-04 17:50:17 +10:00 коммит произвёл Dave Airlie
Родитель d1b985572a
Коммит 261a3ad426
1 изменённых файлов: 11 добавлений и 0 удалений

Просмотреть файл

@ -400,7 +400,18 @@ void ast_init_3rdtx(struct drm_device *dev)
if (ast->tx_chip_type == AST_TX_SIL164)
ast_init_dvo(dev);
else {
/*
* Set DAC source to VGA mode in SCU2C via the P2A
* bridge. First configure the P2U to target the SCU
* in case it isn't at this stage.
*/
ast_write32(ast, 0xf004, 0x1e6e0000);
ast_write32(ast, 0xf000, 0x1);
/* Then unlock the SCU with the magic password */
ast_write32(ast, 0x12000, 0x1688a8a8);
ast_write32(ast, 0x12000, 0x1688a8a8);
ast_write32(ast, 0x12000, 0x1688a8a8);
/* Finally, clear bits [17:16] of SCU2c */
data = ast_read32(ast, 0x1202c);
data &= 0xfffcffff;
ast_write32(ast, 0, data);