ixgbe: store permanent address before initializing Rx addresses

We were reading the address after it had been initialized and this results
in the permanent address on the system being changed.  This change corrects
that by storing the address before we re-initialize it.

Signed-off-by: Emil Tantilov <emil.s.tantilov@intel.com>
Tested-by: Stephen Ko <stephen.s.ko@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ixgbe/ixgbe_82598.c

@@ -831,15 +831,15 @@ mac_reset_top:
 		IXGBE_WRITE_REG(hw, IXGBE_AUTOC, hw->mac.orig_autoc);
 	}
 
+	/* Store the permanent mac address */
+	hw->mac.ops.get_mac_addr(hw, hw->mac.perm_addr);
+
 	/*
 	 * Store MAC address from RAR0, clear receive address registers, and
 	 * clear the multicast table
 	 */
 	hw->mac.ops.init_rx_addrs(hw);
 
-	/* Store the permanent mac address */
-	hw->mac.ops.get_mac_addr(hw, hw->mac.perm_addr);
-
 reset_hw_out:
 	if (phy_status)
 		status = phy_status;

drivers/net/ixgbe/ixgbe_82599.c

@@ -965,6 +965,9 @@ mac_reset_top:
 		}
 	}
 
+	/* Store the permanent mac address */
+	hw->mac.ops.get_mac_addr(hw, hw->mac.perm_addr);
+
 	/*
 	 * Store MAC address from RAR0, clear receive address registers, and
 	 * clear the multicast table.  Also reset num_rar_entries to 128,
@@ -973,9 +976,6 @@ mac_reset_top:
 	hw->mac.num_rar_entries = 128;
 	hw->mac.ops.init_rx_addrs(hw);
 
-	/* Store the permanent mac address */
-	hw->mac.ops.get_mac_addr(hw, hw->mac.perm_addr);
-
 	/* Store the permanent SAN mac address */
 	hw->mac.ops.get_san_mac_addr(hw, hw->mac.san_addr);