hpt366: UltraDMA filter for SATA cards (take 2)
The Marvell bridge chips used on HighPoint SATA cards do not seem to support the UltraDMA modes 1, 2, and 3 as well as any MWDMA modes, so the driver needs to account for this in the udma_filter() method. In order to achieve that, do the following changes: - install the method for all chips, not only HPT36x/370 and improve the code formatting by killing the extra tabs while at it; - add to the end of the 'switch' statement in the method cases for HPT372[AN] and HPT374 chips upon which the known SATA cards are based; - use hwif->ultra_mask as a default mask for the ide_dma_filter() method to behave correctly; - move the HPT370[A] cases below the HPT36x case for consistency. While at it, replace the explicit UltraDMA mode masks with ATA_UDMA* constants all over the driver... Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com> Cc: Bob Ham <rah@bash.sh> Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
This commit is contained in:
Sergei Shtylyov
Bartlomiej Zolnierkiewicz
Родитель
6c3c22f3cb
Коммит
2808b0a96a
|
|
@ -1,5 +1,5 @@
|
|||
/*
|
||||
* linux/drivers/ide/pci/hpt366.c Version 1.11 Aug 11, 2007
|
||||
* linux/drivers/ide/pci/hpt366.c Version 1.12 Aug 19, 2007
|
||||
*
|
||||
* Copyright (C) 1999-2003 Andre Hedrick <andre@linux-ide.org>
|
||||
* Portions Copyright (C) 2001 Sun Microsystems, Inc.
|
||||
|
|
@ -114,6 +114,7 @@
|
|||
* unify HPT36x/37x timing setup code and the speedproc handlers by joining
|
||||
* the register setting lists into the table indexed by the clock selected
|
||||
* - set the correct hwif->ultra_mask for each individual chip
|
||||
* - add UltraDMA mode filtering for the HPT37[24] based SATA cards
|
||||
* Sergei Shtylyov, <sshtylyov@ru.mvista.com> or <source@mvista.com>
|
||||
*/
|
||||
|
||||
|
|
@ -518,42 +519,44 @@ static int check_in_drive_list(ide_drive_t *drive, const char **list)
|
|||
}
|
||||
|
||||
/*
|
||||
* Note for the future; the SATA hpt37x we must set
|
||||
* either PIO or UDMA modes 0,4,5
|
||||
* The Marvell bridge chips used on the HighPoint SATA cards do not seem
|
||||
* to support the UltraDMA modes 1, 2, and 3 as well as any MWDMA modes...
|
||||
*/
|
||||
|
||||
static u8 hpt3xx_udma_filter(ide_drive_t *drive)
|
||||
{
|
||||
struct hpt_info *info = pci_get_drvdata(HWIF(drive)->pci_dev);
|
||||
u8 mask;
|
||||
ide_hwif_t *hwif = HWIF(drive);
|
||||
struct hpt_info *info = pci_get_drvdata(hwif->pci_dev);
|
||||
u8 mask = hwif->ultra_mask;
|
||||
|
||||
switch (info->chip_type) {
|
||||
case HPT370A:
|
||||
if (!HPT370_ALLOW_ATA100_5 ||
|
||||
check_in_drive_list(drive, bad_ata100_5))
|
||||
return 0x1f;
|
||||
else
|
||||
return 0x3f;
|
||||
case HPT370:
|
||||
if (!HPT370_ALLOW_ATA100_5 ||
|
||||
check_in_drive_list(drive, bad_ata100_5))
|
||||
mask = 0x1f;
|
||||
else
|
||||
mask = 0x3f;
|
||||
break;
|
||||
case HPT36x:
|
||||
if (!HPT366_ALLOW_ATA66_4 ||
|
||||
check_in_drive_list(drive, bad_ata66_4))
|
||||
mask = 0x0f;
|
||||
else
|
||||
mask = 0x1f;
|
||||
mask = ATA_UDMA3;
|
||||
|
||||
if (!HPT366_ALLOW_ATA66_3 ||
|
||||
check_in_drive_list(drive, bad_ata66_3))
|
||||
mask = 0x07;
|
||||
mask = ATA_UDMA2;
|
||||
break;
|
||||
case HPT370:
|
||||
if (!HPT370_ALLOW_ATA100_5 ||
|
||||
check_in_drive_list(drive, bad_ata100_5))
|
||||
mask = ATA_UDMA4;
|
||||
break;
|
||||
case HPT370A:
|
||||
if (!HPT370_ALLOW_ATA100_5 ||
|
||||
check_in_drive_list(drive, bad_ata100_5))
|
||||
return ATA_UDMA4;
|
||||
case HPT372 :
|
||||
case HPT372A:
|
||||
case HPT372N:
|
||||
case HPT374 :
|
||||
if (ide_dev_is_sata(drive->id))
|
||||
mask &= ~0x0e;
|
||||
/* Fall thru */
|
||||
default:
|
||||
return 0x7f;
|
||||
return mask;
|
||||
}
|
||||
|
||||
return check_in_drive_list(drive, bad_ata33) ? 0x00 : mask;
|
||||
|
|
@ -1253,7 +1256,6 @@ static void __devinit init_hwif_hpt366(ide_hwif_t *hwif)
|
|||
hwif->maskproc = &hpt3xx_maskproc;
|
||||
hwif->busproc = &hpt3xx_busproc;
|
||||
|
||||
if (chip_type <= HPT370A)
|
||||
hwif->udma_filter = &hpt3xx_udma_filter;
|
||||
|
||||
/*
|
||||
|
|
@ -1504,19 +1506,19 @@ static int __devinit init_setup_hpt366(struct pci_dev *dev, ide_pci_device_t *d)
|
|||
d->host_flags |= IDE_HFLAG_SINGLE;
|
||||
d->enablebits[0].mask = d->enablebits[0].val = 0x10;
|
||||
|
||||
d->udma_mask = HPT366_ALLOW_ATA66_3 ?
|
||||
(HPT366_ALLOW_ATA66_4 ? 0x1f : 0x0f) : 0x07;
|
||||
d->udma_mask = HPT366_ALLOW_ATA66_3 ? (HPT366_ALLOW_ATA66_4 ?
|
||||
ATA_UDMA4 : ATA_UDMA3) : ATA_UDMA2;
|
||||
break;
|
||||
case 3:
|
||||
case 4:
|
||||
d->udma_mask = HPT370_ALLOW_ATA100_5 ? 0x3f : 0x1f;
|
||||
d->udma_mask = HPT370_ALLOW_ATA100_5 ? ATA_UDMA5 : ATA_UDMA4;
|
||||
break;
|
||||
default:
|
||||
rev = 6;
|
||||
/* fall thru */
|
||||
case 5:
|
||||
case 6:
|
||||
d->udma_mask = HPT372_ALLOW_ATA133_6 ? 0x7f : 0x3f;
|
||||
d->udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5;
|
||||
break;
|
||||
}
|
||||
|
||||
|
|
@ -1577,7 +1579,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
|
|||
.init_dma = init_dma_hpt366,
|
||||
.autodma = AUTODMA,
|
||||
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
|
||||
.udma_mask = HPT372_ALLOW_ATA133_6 ? 0x7f : 0x3f,
|
||||
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
|
||||
.bootable = OFF_BOARD,
|
||||
.extra = 240,
|
||||
.pio_mask = ATA_PIO4,
|
||||
|
|
@ -1589,7 +1591,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
|
|||
.init_dma = init_dma_hpt366,
|
||||
.autodma = AUTODMA,
|
||||
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
|
||||
.udma_mask = HPT302_ALLOW_ATA133_6 ? 0x7f : 0x3f,
|
||||
.udma_mask = HPT302_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
|
||||
.bootable = OFF_BOARD,
|
||||
.extra = 240,
|
||||
.pio_mask = ATA_PIO4,
|
||||
|
|
@ -1601,7 +1603,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
|
|||
.init_dma = init_dma_hpt366,
|
||||
.autodma = AUTODMA,
|
||||
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
|
||||
.udma_mask = HPT371_ALLOW_ATA133_6 ? 0x7f : 0x3f,
|
||||
.udma_mask = HPT371_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
|
||||
.bootable = OFF_BOARD,
|
||||
.extra = 240,
|
||||
.pio_mask = ATA_PIO4,
|
||||
|
|
@ -1613,7 +1615,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
|
|||
.init_dma = init_dma_hpt366,
|
||||
.autodma = AUTODMA,
|
||||
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
|
||||
.udma_mask = 0x3f,
|
||||
.udma_mask = ATA_UDMA5,
|
||||
.bootable = OFF_BOARD,
|
||||
.extra = 240,
|
||||
.pio_mask = ATA_PIO4,
|
||||
|
|
@ -1625,7 +1627,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
|
|||
.init_dma = init_dma_hpt366,
|
||||
.autodma = AUTODMA,
|
||||
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
|
||||
.udma_mask = HPT372_ALLOW_ATA133_6 ? 0x7f : 0x3f,
|
||||
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
|
||||
.bootable = OFF_BOARD,
|
||||
.extra = 240,
|
||||
.pio_mask = ATA_PIO4,
|
||||
|
|
|
|||
Загрузка…
Ссылка в новой задаче