mac80211: clear timer bits when disconnecting

There's a corner case that can happen when we
suspend with a timer running, then resume and
disconnect. If we connect again, suspend and
resume we might start timers that shouldn't be
running. Reset the timer flags to avoid this.

This affects both mesh and managed modes.

Signed-off-by: Johannes Berg <johannes.berg@intel.com>

net/mac80211/mesh.c

@@ -634,6 +634,8 @@ void ieee80211_stop_mesh(struct ieee80211_sub_if_data *sdata)
 	local->fif_other_bss--;
 	atomic_dec(&local->iff_allmultis);
 	ieee80211_configure_filter(local);
+
+	sdata->u.mesh.timers_running = 0;
 }
 
 static void ieee80211_mesh_rx_bcn_presp(struct ieee80211_sub_if_data *sdata,

net/mac80211/mlme.c

@@ -1430,6 +1430,8 @@ static void ieee80211_set_disassoc(struct ieee80211_sub_if_data *sdata,
 	del_timer_sync(&sdata->u.mgd.bcn_mon_timer);
 	del_timer_sync(&sdata->u.mgd.timer);
 	del_timer_sync(&sdata->u.mgd.chswitch_timer);
+
+	sdata->u.mgd.timers_running = 0;
 }
 
 void ieee80211_sta_rx_notify(struct ieee80211_sub_if_data *sdata,