ASoC: tlv320dac33: Use codec defaults for LOM/LOP and DAC power

Do not change the codec defaults for the following registers:
0x40, 0x41: Line output gains, do not use amplification
0x42: LOM/LOP Voltage hold, and selection
0x44: LOM inversion control

It has been found, that the values configured to these registers
can cause amplification, which can make the output of DAC33
distorted.

The codec reset values are considered safe in all environmnts.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@nokia.com>
Acked-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Liam Girdwood <lrg@slimlogic.co.uk>
This commit is contained in:
Peter Ujfalusi 2010-05-06 12:04:25 +03:00 коммит произвёл Liam Girdwood
Родитель 6f3991152f
Коммит 2f005471e2
1 изменённых файлов: 0 добавлений и 11 удалений

Просмотреть файл

@ -303,21 +303,10 @@ static void dac33_init_chip(struct snd_soc_codec *codec)
/* C : (defaults) */
dac33_write(codec, DAC33_DAC_CTRL_C, 0x00);
/* 64-65 : L&R DAC power control
Line In -> OUT 1V/V Gain, DAC -> OUT 4V/V Gain*/
dac33_write(codec, DAC33_LDAC_PWR_CTRL, DAC33_LROUT_GAIN(2));
dac33_write(codec, DAC33_RDAC_PWR_CTRL, DAC33_LROUT_GAIN(2));
/* 73 : volume soft stepping control,
clock source = internal osc (?) */
dac33_write(codec, DAC33_ANA_VOL_SOFT_STEP_CTRL, DAC33_VOLCLKEN);
/* 66 : LOP/LOM Modes */
dac33_write(codec, DAC33_OUT_AMP_CM_CTRL, 0xff);
/* 68 : LOM inverted from LOP */
dac33_write(codec, DAC33_OUT_AMP_CTRL, (3<<2));
dac33_write(codec, DAC33_PWR_CTRL, DAC33_PDNALLB);
/* Restore only selected registers (gains mostly) */