qd65xx: convert to use ide_timing_find_mode()

There should be no functional changes caused by this patch.

Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

drivers/ide/Kconfig

@@ -1011,6 +1011,7 @@ config BLK_DEV_HT6560B
 
 config BLK_DEV_QD65XX
 	tristate "QDI QD65xx support"
+	select IDE_TIMINGS
 	help
 	  This driver is enabled at runtime using the "qd65xx.probe" kernel
 	  boot parameter.  It permits faster I/O speeds to be set.  See the

drivers/ide/legacy/qd65xx.c

@@ -207,6 +207,7 @@ static void qd6500_set_pio_mode(ide_drive_t *drive, const u8 pio)
 static void qd6580_set_pio_mode(ide_drive_t *drive, const u8 pio)
 {
 	ide_hwif_t *hwif = drive->hwif;
+	struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio);
 	unsigned int cycle_time;
 	int active_time   = 175;
 	int recovery_time = 415; /* worst case values from the dos driver */
@@ -236,7 +237,7 @@ static void qd6580_set_pio_mode(ide_drive_t *drive, const u8 pio)
 					active_time = 110;
 					recovery_time = cycle_time - 120;
 				} else {
-					active_time = ide_pio_timings[pio].active_time;
+					active_time = t->active;
 					recovery_time = cycle_time - active_time;
 				}
 		}