ice: Do not check INTEVENT bit for OICR interrupts

According to the hardware spec, checking the INTEVENT bit isn't a
reliable way to detect if an OICR interrupt has occurred. This is
because this bit can be cleared by the hardware/firmware before the
interrupt service routine has run. So instead, just check for OICR
events every time.

Fixes: 940b61af02 ("ice: Initialize PF and setup miscellaneous interrupt")
Signed-off-by: Ben Shelton <benjamin.h.shelton@intel.com>
Signed-off-by: Anirudh Venkataramanan <anirudh.venkataramanan@intel.com>
Tested-by: Tony Brelinski <tonyx.brelinski@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ice/ice_hw_autogen.h

@@ -121,8 +121,6 @@
 #define PFINT_FW_CTL_CAUSE_ENA_S	30
 #define PFINT_FW_CTL_CAUSE_ENA_M	BIT(PFINT_FW_CTL_CAUSE_ENA_S)
 #define PFINT_OICR			0x0016CA00
-#define PFINT_OICR_INTEVENT_S		0
-#define PFINT_OICR_INTEVENT_M		BIT(PFINT_OICR_INTEVENT_S)
 #define PFINT_OICR_HLP_RDY_S		14
 #define PFINT_OICR_HLP_RDY_M		BIT(PFINT_OICR_HLP_RDY_S)
 #define PFINT_OICR_CPM_RDY_S		15

drivers/net/ethernet/intel/ice/ice_main.c

@@ -1722,9 +1722,6 @@ static irqreturn_t ice_misc_intr(int __always_unused irq, void *data)
 	oicr = rd32(hw, PFINT_OICR);
 	ena_mask = rd32(hw, PFINT_OICR_ENA);
 
-	if (!(oicr & PFINT_OICR_INTEVENT_M))
-		goto ena_intr;
-
 	if (oicr & PFINT_OICR_GRST_M) {
 		u32 reset;
 		/* we have a reset warning */
@@ -1782,7 +1779,6 @@ static irqreturn_t ice_misc_intr(int __always_unused irq, void *data)
 	}
 	ret = IRQ_HANDLED;
 
-ena_intr:
 	/* re-enable interrupt causes that are not handled during this pass */
 	wr32(hw, PFINT_OICR_ENA, ena_mask);
 	if (!test_bit(__ICE_DOWN, pf->state)) {