tg3: Fix link check in tg3_adjust_link

The tg3 driver tried to detect link changes by comparing the tg3 local
active_speed member with SPEED_UNKNOWN (or formerly SPEED_INVALID).
This check is not correct, since phylib will never set its speed member
to either of these two values.  The code only appeared to work because
tg3 initializes active_speed to SPEED_INVALID during tg3_init_one.  This
patch introduces a new "old_link" tg3 member and then compares the
phy_device's link member against it to detect link state changes.

Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Matt Carlson 2012-02-22 12:35:18 +00:00 коммит произвёл David S. Miller
Родитель 9f6f9af769
Коммит 34655ad638
2 изменённых файлов: 5 добавлений и 2 удалений

Просмотреть файл

@ -1819,13 +1819,13 @@ static void tg3_adjust_link(struct net_device *dev)
(6 << TX_LENGTHS_IPG_SHIFT) |
(32 << TX_LENGTHS_SLOT_TIME_SHIFT)));
if ((phydev->link && tp->link_config.active_speed == SPEED_UNKNOWN) ||
(!phydev->link && tp->link_config.active_speed != SPEED_UNKNOWN) ||
if (phydev->link != tp->old_link ||
phydev->speed != tp->link_config.active_speed ||
phydev->duplex != tp->link_config.active_duplex ||
oldflowctrl != tp->link_config.active_flowctrl)
linkmesg = 1;
tp->old_link = phydev->link;
tp->link_config.active_speed = phydev->speed;
tp->link_config.active_duplex = phydev->duplex;
@ -13352,6 +13352,8 @@ static void __devinit tg3_phy_init_link_config(struct tg3 *tp)
tp->link_config.autoneg = AUTONEG_ENABLE;
tp->link_config.active_speed = SPEED_UNKNOWN;
tp->link_config.active_duplex = DUPLEX_UNKNOWN;
tp->old_link = -1;
}
static int __devinit tg3_phy_probe(struct tg3 *tp)

Просмотреть файл

@ -3064,6 +3064,7 @@ struct tg3 {
struct mii_bus *mdio_bus;
int mdio_irq[PHY_MAX_ADDR];
int old_link;
u8 phy_addr;