powerpc: add mmc-spi-slot bindings
The bindings describes a case where MMC/SD/SDIO slot directly connected to a SPI bus. Such setups are widely used on embedded PowerPC boards. The patch also adds the mmc-spi-slot entry to the OpenFirmware modalias table. Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com> Cc: David Brownell <david-b@pacbell.net> Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org> Cc: Kumar Gala <galak@gate.crashing.org> Cc: Grant Likely <grant.likely@secretlab.ca> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This commit is contained in:
Родитель
35b4b3c0c1
Коммит
3f1c6ebf57
|
@ -0,0 +1,23 @@
|
|||
MMC/SD/SDIO slot directly connected to a SPI bus
|
||||
|
||||
Required properties:
|
||||
- compatible : should be "mmc-spi-slot".
|
||||
- reg : should specify SPI address (chip-select number).
|
||||
- spi-max-frequency : maximum frequency for this device (Hz).
|
||||
- voltage-ranges : two cells are required, first cell specifies minimum
|
||||
slot voltage (mV), second cell specifies maximum slot voltage (mV).
|
||||
Several ranges could be specified.
|
||||
- gpios : (optional) may specify GPIOs in this order: Card-Detect GPIO,
|
||||
Write-Protect GPIO.
|
||||
|
||||
Example:
|
||||
|
||||
mmc-slot@0 {
|
||||
compatible = "fsl,mpc8323rdb-mmc-slot",
|
||||
"mmc-spi-slot";
|
||||
reg = <0>;
|
||||
gpios = <&qe_pio_d 14 1
|
||||
&qe_pio_d 15 0>;
|
||||
voltage-ranges = <3300 3300>;
|
||||
spi-max-frequency = <50000000>;
|
||||
};
|
|
@ -446,6 +446,7 @@ struct of_modalias_table {
|
|||
};
|
||||
static struct of_modalias_table of_modalias_table[] = {
|
||||
{ "fsl,mcu-mpc8349emitx", "mcu-mpc8349emitx" },
|
||||
{ "mmc-spi-slot", "mmc_spi" },
|
||||
};
|
||||
|
||||
/**
|
||||
|
|
Загрузка…
Ссылка в новой задаче