iio: adis16480: Use irq types instead of flags

The value retrieved by `irqd_get_trigger_type()` is not an irq flag.
While the values are the same, the meaning is different.

Signed-off-by: Nuno Sá <nuno.sa@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>

drivers/iio/imu/adis16480.c

@@ -1102,12 +1102,12 @@ static int adis16480_config_irq_pin(struct device_node *of_node,
 	/*
 	 * Get the interrupt line behaviour. The data ready polarity can be
 	 * configured as positive or negative, corresponding to
-	 * IRQF_TRIGGER_RISING or IRQF_TRIGGER_FALLING respectively.
+	 * IRQ_TYPE_EDGE_RISING or IRQ_TYPE_EDGE_FALLING respectively.
 	 */
 	irq_type = irqd_get_trigger_type(desc);
-	if (irq_type == IRQF_TRIGGER_RISING) { /* Default */
+	if (irq_type == IRQ_TYPE_EDGE_RISING) { /* Default */
 		val |= ADIS16480_DRDY_POL(1);
-	} else if (irq_type == IRQF_TRIGGER_FALLING) {
+	} else if (irq_type == IRQ_TYPE_EDGE_FALLING) {
 		val |= ADIS16480_DRDY_POL(0);
 	} else {
 		dev_err(&st->adis.spi->dev,