dt-bindings: net: correct interrupt flags in examples

GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags, assuming the author of the code wanted same
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW  => IRQ_TYPE_LEVEL_LOW
  ACTIVE_HIGH => IRQ_TYPE_LEVEL_HIGH

Fixes: a1a8b4594f ("NFC: pn544: i2c: Add DTS Documentation")
Fixes: 6be88670fc ("NFC: nxp-nci_i2c: Add I2C support to NXP NCI driver")
Fixes: e3b3292215 ("dt-bindings: can: tcan4x5x: Update binding to use interrupt property")
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Marc Kleine-Budde <mkl@pengutronix.de> # for tcan4x5x.txt
Link: https://lore.kernel.org/r/20201026153620.89268-1-krzk@kernel.org
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

Documentation/devicetree/bindings/net/can/tcan4x5x.txt

@@ -33,7 +33,7 @@ tcan4x5x: tcan4x5x@0 {
 		spi-max-frequency = <10000000>;
 		bosch,mram-cfg = <0x0 0 0 32 0 0 1 1>;
 		interrupt-parent = <&gpio1>;
-		interrupts = <14 GPIO_ACTIVE_LOW>;
+		interrupts = <14 IRQ_TYPE_LEVEL_LOW>;
 		device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
 		device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>;
 		reset-gpios = <&gpio1 27 GPIO_ACTIVE_HIGH>;

Documentation/devicetree/bindings/net/nfc/nxp-nci.txt

@@ -25,7 +25,7 @@ Example (for ARM-based BeagleBone with NPC100 NFC controller on I2C2):
 		clock-frequency = <100000>;
 
 		interrupt-parent = <&gpio1>;
-		interrupts = <29 GPIO_ACTIVE_HIGH>;
+		interrupts = <29 IRQ_TYPE_LEVEL_HIGH>;
 
 		enable-gpios = <&gpio0 30 GPIO_ACTIVE_HIGH>;
 		firmware-gpios = <&gpio0 31 GPIO_ACTIVE_HIGH>;

Documentation/devicetree/bindings/net/nfc/pn544.txt

@@ -25,7 +25,7 @@ Example (for ARM-based BeagleBone with PN544 on I2C2):
 		clock-frequency = <400000>;
 
 		interrupt-parent = <&gpio1>;
-		interrupts = <17 GPIO_ACTIVE_HIGH>;
+		interrupts = <17 IRQ_TYPE_LEVEL_HIGH>;
 
 		enable-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
 		firmware-gpios = <&gpio3 19 GPIO_ACTIVE_HIGH>;