Bluetooth: btusb: support public address configuration for ath3012

Set hdev->set_bdaddr handler for ath3012. It sends the vendor specific HCI
command to change the public address. The change doesn't persist across
power cycle.

Signed-off-by: Toshi Kikuchi <toshik@chromium.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

drivers/bluetooth/btusb.c

@@ -1943,6 +1943,31 @@ static int btusb_set_bdaddr_bcm(struct hci_dev *hdev, const bdaddr_t *bdaddr)
 	return 0;
 }
 
+static int btusb_set_bdaddr_ath3012(struct hci_dev *hdev,
+				    const bdaddr_t *bdaddr)
+{
+	struct sk_buff *skb;
+	u8 buf[10];
+	long ret;
+
+	buf[0] = 0x01;
+	buf[1] = 0x01;
+	buf[2] = 0x00;
+	buf[3] = sizeof(bdaddr_t);
+	memcpy(buf + 4, bdaddr, sizeof(bdaddr_t));
+
+	skb = __hci_cmd_sync(hdev, 0xfc0b, sizeof(buf), buf, HCI_INIT_TIMEOUT);
+	if (IS_ERR(skb)) {
+		ret = PTR_ERR(skb);
+		BT_ERR("%s: Change address command failed (%ld)",
+		       hdev->name, ret);
+		return ret;
+	}
+	kfree_skb(skb);
+
+	return 0;
+}
+
 static int btusb_probe(struct usb_interface *intf,
 		       const struct usb_device_id *id)
 {
@@ -2058,6 +2083,9 @@ static int btusb_probe(struct usb_interface *intf,
 	if (id->driver_info & BTUSB_INTEL_BOOT)
 		set_bit(HCI_QUIRK_RAW_DEVICE, &hdev->quirks);
 
+	if (id->driver_info & BTUSB_ATH3012)
+		hdev->set_bdaddr = btusb_set_bdaddr_ath3012;
+
 	/* Interface numbers are hardcoded in the specification */
 	data->isoc = usb_ifnum_to_if(data->udev, 1);