parisc: Makefile: Adjust order in which drivers should be loaded

This is the order in which the drivers are initialized in setup.c.
The order is important when the drivers are convertet to use the
initcall_*() startup framework.

Signed-off-by: Helge Deller <deller@gmx.de>

drivers/parisc/Makefile

@@ -1,25 +1,27 @@
 # SPDX-License-Identifier: GPL-2.0
 #
-# Makefile for most of the non-PCI devices in PA-RISC machines
+# Makefile PCI and non-PCI devices in PA-RISC machines
+#
+# Keep the order below, e.g.
+# - ccio before any potential subdevices
+# - gsc is required before lasi and wax
+# - asp and wax before the EISA adapters for the IRQ regions
+# - EISA must come before PCI to be sure it gets IRQ region
 #
 
-# I/O SAPIC is also on IA64 platforms.
-# The two could be merged into a common source some day.
 obj-$(CONFIG_IOSAPIC)		+= iosapic.o
 obj-$(CONFIG_IOMMU_SBA)		+= sba_iommu.o
 obj-$(CONFIG_PCI_LBA)		+= lba_pci.o
 obj-$(CONFIG_IOMMU_CCIO)	+= ccio-dma.o
 
 obj-$(CONFIG_GSC)		+= gsc.o
-
-obj-$(CONFIG_HPPB)		+= hppb.o
-obj-$(CONFIG_GSC_DINO)		+= dino.o
 obj-$(CONFIG_GSC_LASI)		+= lasi.o asp.o
 obj-$(CONFIG_GSC_WAX)		+= wax.o
 obj-$(CONFIG_EISA)		+= eisa.o eisa_enumerator.o eisa_eeprom.o
+obj-$(CONFIG_HPPB)		+= hppb.o
+obj-$(CONFIG_GSC_DINO)		+= dino.o
 
 obj-$(CONFIG_SUPERIO)		+= superio.o
 obj-$(CONFIG_CHASSIS_LCD_LED)	+= led.o
 obj-$(CONFIG_PDC_STABLE)	+= pdc_stable.o
 obj-y				+= power.o
-