ARM: 7864/1: Handle 64-bit memory in case of 32-bit phys_addr_t

Use CONFIG_ARCH_PHYS_ADDR_T_64BIT to determine
if ignoring or truncating of memory banks is
neccessary. This may be needed in the case of
64-bit memory bank addresses but when phys_addr_t
is kept 32-bit.

Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

arch/arm/kernel/setup.c

@@ -624,6 +624,7 @@ void __init dump_machine_table(void)
 int __init arm_add_memory(u64 start, u64 size)
 {
 	struct membank *bank = &meminfo.bank[meminfo.nr_banks];
+	u64 aligned_start;
 
 	if (meminfo.nr_banks >= NR_BANKS) {
 		printk(KERN_CRIT "NR_BANKS too low, "
@@ -636,10 +637,16 @@ int __init arm_add_memory(u64 start, u64 size)
 	 * Size is appropriately rounded down, start is rounded up.
 	 */
 	size -= start & ~PAGE_MASK;
-	bank->start = PAGE_ALIGN(start);
+	aligned_start = PAGE_ALIGN(start);
 
-#ifndef CONFIG_ARM_LPAE
+#ifndef CONFIG_ARCH_PHYS_ADDR_T_64BIT
-	if (bank->start + size < bank->start) {
+	if (aligned_start > ULONG_MAX) {
+		printk(KERN_CRIT "Ignoring memory at 0x%08llx outside "
+		       "32-bit physical address space\n", (long long)start);
+		return -EINVAL;
+	}
+
+	if (aligned_start + size > ULONG_MAX) {
 		printk(KERN_CRIT "Truncating memory at 0x%08llx to fit in "
 			"32-bit physical address space\n", (long long)start);
 		/*
@@ -647,10 +654,11 @@ int __init arm_add_memory(u64 start, u64 size)
 		 * 32 bits, we use ULONG_MAX as the upper limit rather than 4GB.
 		 * This means we lose a page after masking.
 		 */
-		size = ULONG_MAX - bank->start;
+		size = ULONG_MAX - aligned_start;
 	}
 #endif
 
+	bank->start = aligned_start;
 	bank->size = size & ~(phys_addr_t)(PAGE_SIZE - 1);
 
 	/*