signal/microblaze: Use force_sig_fault where appropriate

Filling in struct siginfo before calling force_sig_info a tedious and
error prone process, where once in a great while the wrong fields
are filled out, and siginfo has been inconsistently cleared.

Simplify this process by using the helper force_sig_fault.  Which
takes as a parameters all of the information it needs, ensures
all of the fiddly bits of filling in struct siginfo are done properly
and then calls force_sig_info.

In short about a 5 line reduction in code for every time force_sig_info
is called, which makes the calling function clearer.

Cc: Michal Simek <monstr@monstr.eu>
Signed-off-by: "Eric W. Biederman" <ebiederm@xmission.com>
This commit is contained in:
Eric W. Biederman 2018-04-16 11:24:24 -05:00
Родитель ceb91ed182
Коммит 6f467986cf
2 изменённых файлов: 2 добавлений и 16 удалений

Просмотреть файл

@ -60,17 +60,10 @@ asmlinkage void sw_exception(struct pt_regs *regs)
void _exception(int signr, struct pt_regs *regs, int code, unsigned long addr)
{
siginfo_t info;
if (kernel_mode(regs))
die("Exception in kernel mode", regs, signr);
clear_siginfo(&info);
info.si_signo = signr;
info.si_errno = 0;
info.si_code = code;
info.si_addr = (void __user *) addr;
force_sig_info(signr, &info, current);
force_sig_fault(signr, code, (void __user *)addr, current);
}
asmlinkage void full_exception(struct pt_regs *regs, unsigned int type,

Просмотреть файл

@ -289,14 +289,7 @@ out_of_memory:
do_sigbus:
up_read(&mm->mmap_sem);
if (user_mode(regs)) {
siginfo_t info;
clear_siginfo(&info);
info.si_signo = SIGBUS;
info.si_errno = 0;
info.si_code = BUS_ADRERR;
info.si_addr = (void __user *)address;
force_sig_info(SIGBUS, &info, current);
force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)address, current);
return;
}
bad_page_fault(regs, address, SIGBUS);