drbd: use drbd specific ratelimit instead of global printk_ratelimit
using the global printk_ratelimit() may mask other messages. Signed-off-by: Philipp Reisner <philipp.reisner@linbit.com> Signed-off-by: Lars Ellenberg <lars.ellenberg@linbit.com> Signed-off-by: Jens Axboe <jaxboe@fusionio.com>
This commit is contained in:
Родитель
d255e5ff5f
Коммит
7383506c87
|
@ -1725,7 +1725,7 @@ static inline void __drbd_chk_io_error_(struct drbd_conf *mdev, int forcedetach,
|
|||
switch (mdev->ldev->dc.on_io_error) {
|
||||
case EP_PASS_ON:
|
||||
if (!forcedetach) {
|
||||
if (printk_ratelimit())
|
||||
if (__ratelimit(&drbd_ratelimit_state))
|
||||
dev_err(DEV, "Local IO failed in %s."
|
||||
"Passing error on...\n", where);
|
||||
break;
|
||||
|
|
|
@ -3783,7 +3783,7 @@ _drbd_insert_fault(struct drbd_conf *mdev, unsigned int type)
|
|||
if (ret) {
|
||||
fault_count++;
|
||||
|
||||
if (printk_ratelimit())
|
||||
if (__ratelimit(&drbd_ratelimit_state))
|
||||
dev_warn(DEV, "***Simulating %s failure\n",
|
||||
_drbd_fault_str(type));
|
||||
}
|
||||
|
|
Загрузка…
Ссылка в новой задаче