[SCSI] aic79xx: Avoid renegotiation on inquiry

Because of some quirk in the SCSI spec the aic79xx driver chose to
force a renegotiation when sending an inquiry. This should better
be handled by the upper layers if required at all.

Signed-off-by: Hannes Reinecke <hare@suse.de>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
This commit is contained in:
Hannes Reinecke 2006-03-08 13:00:07 +01:00 коммит произвёл James Bottomley
Родитель 986a25f96a
Коммит 76744f429a
1 изменённых файлов: 0 добавлений и 24 удалений

Просмотреть файл

@ -1526,30 +1526,6 @@ ahd_linux_run_command(struct ahd_softc *ahd, struct ahd_linux_device *dev,
if ((tstate->auto_negotiate & mask) != 0) {
scb->flags |= SCB_AUTO_NEGOTIATE;
scb->hscb->control |= MK_MESSAGE;
} else if (cmd->cmnd[0] == INQUIRY
&& (tinfo->curr.offset != 0
|| tinfo->curr.width != MSG_EXT_WDTR_BUS_8_BIT
|| tinfo->curr.ppr_options != 0)
&& (tinfo->curr.ppr_options & MSG_EXT_PPR_IU_REQ)==0) {
/*
* The SCSI spec requires inquiry
* commands to complete without
* reporting unit attention conditions.
* Because of this, an inquiry command
* that occurs just after a device is
* reset will result in a data phase
* with mismatched negotiated rates.
* The core already forces a renegotiation
* for reset events that are visible to
* our controller or that we initiate,
* but a third party device reset or a
* hot-plug insertion can still cause this
* issue. Therefore, we force a re-negotiation
* for every inquiry command unless we
* are async.
*/
scb->flags |= SCB_NEGOTIATE;
scb->hscb->control |= MK_MESSAGE;
}
if ((dev->flags & (AHD_DEV_Q_TAGGED|AHD_DEV_Q_BASIC)) != 0) {