ARM: STi: stih416: Add support for the FSM Serial Flash Controller

Here we add the necessary device nodes required for successful device
probing and Pinctrl setup for the FSM when booting on an STiH416 (Orly2).

Acked-by: Srinivas Kandagatla <srinivas.kandagatla@st.com>
Acked-by Angus Clark <angus.clark@st.com>
Acked-by: Brian Norris <computersforpeace@gmail.com>
Acked-by: Maxime Coquelin <maxime.coquelin@st.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arch/arm/boot/dts/stih416-pinctrl.dtsi

@@ -310,6 +310,19 @@
 					};
 				};
 			};
+
+			fsm {
+				pinctrl_fsm: fsm {
+					st,pins {
+						spi-fsm-clk  = <&PIO12 2 ALT1 OUT>;
+						spi-fsm-cs   = <&PIO12 3 ALT1 OUT>;
+						spi-fsm-mosi = <&PIO12 4 ALT1 OUT>;
+						spi-fsm-miso = <&PIO12 5 ALT1 IN>;
+						spi-fsm-hol  = <&PIO12 6 ALT1 OUT>;
+						spi-fsm-wp   = <&PIO12 7 ALT1 OUT>;
+					};
+				};
+			};
 		};
 
 		pin-controller-rear {

arch/arm/boot/dts/stih416.dtsi

@@ -212,5 +212,17 @@
 			resets		= <&softreset STIH416_IRB_SOFTRESET>;
 		};
 
+		/* FSM */
+		spifsm: spifsm@fe902000 {
+			compatible	   = "st,spi-fsm";
+			reg		   = <0xfe902000 0x1000>;
+			pinctrl-0	   = <&pinctrl_fsm>;
+
+			st,syscfg	   = <&syscfg_rear>;
+			st,boot-device-reg = <0x958>;
+			st,boot-device-spi = <0x1a>;
+
+			status = "disabled";
+		};
 	};
 };