ARM: dts: stm32: add SPI1 support on stm32mp157c-ev1

This patch adds SPI1 support on stm32mp157c-ev1 board.
SPI1 is available on GPIO expansion connector but kept disabled
so these pins can be used as GPIOs by default.

Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>

arch/arm/boot/dts/stm32mp157-pinctrl.dtsi

@@ -294,7 +294,6 @@
 			pins-are-numbered;
 			interrupt-parent = <&exti>;
 			st,syscfg = <&exti 0x60 0xff>;
-			status = "disabled";
 
 			gpioz: gpio@54004000 {
 				gpio-controller;
@@ -318,6 +317,21 @@
 					slew-rate = <0>;
 				};
 			};
+
+			spi1_pins_a: spi1-0 {
+				pins1 {
+					pinmux = <STM32_PINMUX('Z', 0, AF5)>, /* SPI1_SCK */
+						 <STM32_PINMUX('Z', 2, AF5)>; /* SPI1_MOSI */
+					bias-disable;
+					drive-push-pull;
+					slew-rate = <1>;
+				};
+
+				pins2 {
+					pinmux = <STM32_PINMUX('Z', 1, AF5)>; /* SPI1_MISO */
+					bias-disable;
+				};
+			};
 		};
 	};
 };

arch/arm/boot/dts/stm32mp157c-ev1.dts

@@ -73,6 +73,12 @@
 	};
 };
 
+&spi1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&spi1_pins_a>;
+	status = "disabled";
+};
+
 &timers2 {
 	status = "disabled";
 	pwm {