ARM: OMAP: Merge driver headers from N800 tree

This patch merges omap specific driver headers from
N800 tree.

Signed-off-by: Kai Svahn <kai.svahn@nokia.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
This commit is contained in:
Kai Svahn 2007-01-26 13:14:34 -08:00 коммит произвёл Tony Lindgren
Родитель 2330059794
Коммит 8777297b5e
5 изменённых файлов: 219 добавлений и 1 удалений

Просмотреть файл

@ -0,0 +1,12 @@
#ifndef _BLIZZARD_H
#define _BLIZZARD_H
struct blizzard_platform_data {
void (*power_up)(struct device *dev);
void (*power_down)(struct device *dev);
unsigned long (*get_clock_rate)(struct device *dev);
unsigned te_connected : 1;
};
#endif

Просмотреть файл

@ -0,0 +1,101 @@
/*
* linux/include/asm-arm/arch-omap2/eac.h
*
* Defines for Enhanced Audio Controller
*
* Contact: Jarkko Nikula <jarkko.nikula@nokia.com>
*
* Copyright (C) 2006 Nokia Corporation
* Copyright (C) 2004 Texas Instruments, Inc.
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* version 2 as published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful, but
* WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
* General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA
* 02110-1301 USA
*
*/
#ifndef __ASM_ARM_ARCH_OMAP2_EAC_H
#define __ASM_ARM_ARCH_OMAP2_EAC_H
#include <asm/arch/io.h>
#include <asm/arch/hardware.h>
#include <asm/irq.h>
#include <sound/driver.h>
#include <sound/core.h>
/* master codec clock source */
#define EAC_MCLK_EXT_MASK 0x100
enum eac_mclk_src {
EAC_MCLK_INT_11290000, /* internal 96 MHz / 8.5 = 11.29 Mhz */
EAC_MCLK_EXT_11289600 = EAC_MCLK_EXT_MASK,
EAC_MCLK_EXT_12288000,
EAC_MCLK_EXT_2x11289600,
EAC_MCLK_EXT_2x12288000,
};
/* codec port interface mode */
enum eac_codec_mode {
EAC_CODEC_PCM,
EAC_CODEC_AC97,
EAC_CODEC_I2S_MASTER, /* codec port, I.e. EAC is the master */
EAC_CODEC_I2S_SLAVE,
};
/* configuration structure for I2S mode */
struct eac_i2s_conf {
/* if enabled, then first data slot (left channel) is signaled as
* positive level of frame sync EAC.AC_FS */
unsigned polarity_changed_mode:1;
/* if enabled, then serial data starts one clock cycle after the
* of EAC.AC_FS for first audio slot */
unsigned sync_delay_enable:1;
};
/* configuration structure for EAC codec port */
struct eac_codec {
enum eac_mclk_src mclk_src;
enum eac_codec_mode codec_mode;
union {
struct eac_i2s_conf i2s;
} codec_conf;
int default_rate; /* audio sampling rate */
int (* set_power)(void *private_data, int dac, int adc);
int (* register_controls)(void *private_data,
struct snd_card *card);
const char *short_name;
void *private_data;
};
/* structure for passing platform dependent data to the EAC driver */
struct eac_platform_data {
int (* init)(struct device *eac_dev);
void (* cleanup)(struct device *eac_dev);
/* these callbacks are used to configure & control external MCLK
* source. NULL if not used */
int (* enable_ext_clocks)(struct device *eac_dev);
void (* disable_ext_clocks)(struct device *eac_dev);
};
extern void omap_init_eac(struct eac_platform_data *pdata);
extern int eac_register_codec(struct device *eac_dev, struct eac_codec *codec);
extern void eac_unregister_codec(struct device *eac_dev);
extern int eac_set_mode(struct device *eac_dev, int play, int rec);
#endif /* __ASM_ARM_ARCH_OMAP2_EAC_H */

Просмотреть файл

@ -7,6 +7,12 @@
#ifndef __ASM_ARCH_MENELAUS_H
#define __ASM_ARCH_MENELAUS_H
struct device;
struct menelaus_platform_data {
int (* late_init)(struct device *dev);
};
extern int menelaus_register_mmc_callback(void (*callback)(void *data, u8 card_mask),
void *data);
extern void menelaus_unregister_mmc_callback(void);
@ -20,6 +26,19 @@ extern int menelaus_set_vaux(unsigned int mV);
extern int menelaus_set_vdcdc(int dcdc, unsigned int mV);
extern int menelaus_set_slot_sel(int enable);
extern int menelaus_get_slot_pin_states(void);
extern int menelaus_set_vcore_sw(unsigned int mV);
extern int menelaus_set_vcore_hw(unsigned int roof_mV, unsigned int floor_mV);
#define EN_VPLL_SLEEP (1 << 7)
#define EN_VMMC_SLEEP (1 << 6)
#define EN_VAUX_SLEEP (1 << 5)
#define EN_VIO_SLEEP (1 << 4)
#define EN_VMEM_SLEEP (1 << 3)
#define EN_DC3_SLEEP (1 << 2)
#define EN_DC2_SLEEP (1 << 1)
#define EN_VC_SLEEP (1 << 0)
extern int menelaus_set_regulator_sleep(int enable, u32 val);
#if defined(CONFIG_ARCH_OMAP24XX) && defined(CONFIG_MENELAUS)
#define omap_has_menelaus() 1
@ -28,4 +47,3 @@ extern int menelaus_get_slot_pin_states(void);
#endif
#endif

Просмотреть файл

@ -0,0 +1,66 @@
/*
* MMC definitions for OMAP2
*
* Copyright (C) 2006 Nokia Corporation
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#ifndef __OMAP2_MMC_H
#define __OMAP2_MMC_H
#include <linux/types.h>
#include <linux/device.h>
#include <linux/mmc/host.h>
#define OMAP_MMC_MAX_SLOTS 2
struct omap_mmc_platform_data {
unsigned enabled:1;
/* number of slots on board */
unsigned nr_slots:2;
/* nomux means "standard" muxing is wrong on this board, and that
* board-specific code handled it before common init logic.
*/
unsigned nomux:1;
/* 4 wire signaling is optional, and is only used for SD/SDIO and
* MMCv4 */
unsigned wire4:1;
/* set if your board has components or wiring that limits the
* maximum frequency on the MMC bus */
unsigned int max_freq;
/* switch the bus to a new slot */
int (* switch_slot)(struct device *dev, int slot);
/* initialize board-specific MMC functionality, can be NULL if
* not supported */
int (* init)(struct device *dev);
void (* cleanup)(struct device *dev);
struct omap_mmc_slot_data {
int (* set_bus_mode)(struct device *dev, int slot, int bus_mode);
int (* set_power)(struct device *dev, int slot, int power_on, int vdd);
int (* get_ro)(struct device *dev, int slot);
/* return MMC cover switch state, can be NULL if not supported.
*
* possible return values:
* 0 - open
* 1 - closed
*/
int (* get_cover_state)(struct device *dev, int slot);
const char *name;
u32 ocr_mask;
} slots[OMAP_MMC_MAX_SLOTS];
};
extern void omap_set_mmc_info(int host, const struct omap_mmc_platform_data *info);
/* called from board-specific card detection service routine */
extern void omap_mmc_notify_card_detect(struct device *dev, int slot, int detected);
extern void omap_mmc_notify_cover_event(struct device *dev, int slot, int is_closed);
#endif

Просмотреть файл

@ -0,0 +1,21 @@
/*
* include/asm-arm/arch-omap/onenand.h
*
* Copyright (C) 2006 Nokia Corporation
* Author: Juha Yrjola
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/mtd/partitions.h>
struct omap_onenand_platform_data {
int cs;
int gpio_irq;
struct mtd_partition *parts;
int nr_parts;
int (*onenand_setup)(void __iomem *);
int dma_channel;
};