pata/at91: use newly introduced SMC accessors

pata_at91 driver is broken since faee0cc:
"make smc register base soc independent"
Fix it with newly introduced SMC accessors.

The overall action of removal of at91_sys_read/write will allow
to use the pata_at91 on a single zImage kernel.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Cc: linux-ide@vger.kernel.org
This commit is contained in:
Jean-Christophe PLAGNIOL-VILLARD 2011-11-27 19:30:29 +08:00 коммит произвёл Nicolas Ferre
Родитель 59594e13e4
Коммит 88dcde98ad
1 изменённых файлов: 20 добавлений и 26 удалений

Просмотреть файл

@ -207,11 +207,11 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
{
int ret = 0;
int use_iordy;
struct sam9_smc_config smc;
unsigned int t6z; /* data tristate time in ns */
unsigned int cycle; /* SMC Cycle width in MCK ticks */
unsigned int setup; /* SMC Setup width in MCK ticks */
unsigned int pulse; /* CFIOR and CFIOW pulse width in MCK ticks */
unsigned int cs_setup = 0;/* CS4 or CS5 setup width in MCK ticks */
unsigned int cs_pulse; /* CS4 or CS5 pulse width in MCK ticks*/
unsigned int tdf_cycles; /* SMC TDF MCK ticks */
unsigned long mck_hz; /* MCK frequency in Hz */
@ -244,26 +244,20 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
}
dev_dbg(dev, "Use IORDY=%u, TDF Cycles=%u\n", use_iordy, tdf_cycles);
info->mode |= AT91_SMC_TDF_(tdf_cycles);
/* write SMC Setup Register */
at91_sys_write(AT91_SMC_SETUP(info->cs),
AT91_SMC_NWESETUP_(setup) |
AT91_SMC_NRDSETUP_(setup) |
AT91_SMC_NCS_WRSETUP_(cs_setup) |
AT91_SMC_NCS_RDSETUP_(cs_setup));
/* write SMC Pulse Register */
at91_sys_write(AT91_SMC_PULSE(info->cs),
AT91_SMC_NWEPULSE_(pulse) |
AT91_SMC_NRDPULSE_(pulse) |
AT91_SMC_NCS_WRPULSE_(cs_pulse) |
AT91_SMC_NCS_RDPULSE_(cs_pulse));
/* write SMC Cycle Register */
at91_sys_write(AT91_SMC_CYCLE(info->cs),
AT91_SMC_NWECYCLE_(cycle) |
AT91_SMC_NRDCYCLE_(cycle));
/* write SMC Mode Register*/
at91_sys_write(AT91_SMC_MODE(info->cs), info->mode);
/* SMC Setup Register */
smc.nwe_setup = smc.nrd_setup = setup;
smc.ncs_write_setup = smc.ncs_read_setup = 0;
/* SMC Pulse Register */
smc.nwe_pulse = smc.nrd_pulse = pulse;
smc.ncs_write_pulse = smc.ncs_read_pulse = cs_pulse;
/* SMC Cycle Register */
smc.write_cycle = smc.read_cycle = cycle;
/* SMC Mode Register*/
smc.tdf_cycles = tdf_cycles;
smc.mode = info->mode;
sam9_smc_configure(0, info->cs, &smc);
}
static void pata_at91_set_piomode(struct ata_port *ap, struct ata_device *adev)
@ -288,20 +282,20 @@ static unsigned int pata_at91_data_xfer_noirq(struct ata_device *dev,
struct at91_ide_info *info = dev->link->ap->host->private_data;
unsigned int consumed;
unsigned long flags;
unsigned int mode;
struct sam9_smc_config smc;
local_irq_save(flags);
mode = at91_sys_read(AT91_SMC_MODE(info->cs));
sam9_smc_read_mode(0, info->cs, &smc);
/* set 16bit mode before writing data */
at91_sys_write(AT91_SMC_MODE(info->cs),
(mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_16);
smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_16;
sam9_smc_write_mode(0, info->cs, &smc);
consumed = ata_sff_data_xfer(dev, buf, buflen, rw);
/* restore 8bit mode after data is written */
at91_sys_write(AT91_SMC_MODE(info->cs),
(mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_8);
smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_8;
sam9_smc_write_mode(0, info->cs, &smc);
local_irq_restore(flags);
return consumed;