Merge branch 'net-broadcom-Remove-print-of-base-address'

Florian Fainelli says:

====================
net: broadcom: Remove print of base address

Some broadcom MDIO/switch/Ethernet MAC drivers insist on printing the
base register virtual address which has little value.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dsa/bcm_sf2.c

@@ -1188,10 +1188,11 @@ static int bcm_sf2_sw_probe(struct platform_device *pdev)
 	if (ret)
 		goto out_mdio;
 
-	pr_info("Starfighter 2 top: %x.%02x, core: %x.%02x base: 0x%p, IRQs: %d, %d\n",
+	dev_info(&pdev->dev,
-		priv->hw_params.top_rev >> 8, priv->hw_params.top_rev & 0xff,
+		 "Starfighter 2 top: %x.%02x, core: %x.%02x, IRQs: %d, %d\n",
-		priv->hw_params.core_rev >> 8, priv->hw_params.core_rev & 0xff,
+		 priv->hw_params.top_rev >> 8, priv->hw_params.top_rev & 0xff,
-		priv->core, priv->irq0, priv->irq1);
+		 priv->hw_params.core_rev >> 8, priv->hw_params.core_rev & 0xff,
+		 priv->irq0, priv->irq1);
 
 	return 0;
 

drivers/net/ethernet/broadcom/bcmsysport.c

@@ -2598,11 +2598,11 @@ static int bcm_sysport_probe(struct platform_device *pdev)
 
 	priv->rev = topctrl_readl(priv, REV_CNTL) & REV_MASK;
 	dev_info(&pdev->dev,
-		 "Broadcom SYSTEMPORT%s" REV_FMT
+		 "Broadcom SYSTEMPORT%s " REV_FMT
-		 " at 0x%p (irqs: %d, %d, TXQs: %d, RXQs: %d)\n",
+		 " (irqs: %d, %d, TXQs: %d, RXQs: %d)\n",
 		 priv->is_lite ? " Lite" : "",
 		 (priv->rev >> 8) & 0xff, priv->rev & 0xff,
-		 priv->base, priv->irq0, priv->irq1, txq, rxq);
+		 priv->irq0, priv->irq1, txq, rxq);
 
 	return 0;
 

drivers/net/phy/mdio-bcm-unimac.c

@@ -292,7 +292,7 @@ static int unimac_mdio_probe(struct platform_device *pdev)
 
 	platform_set_drvdata(pdev, priv);
 
-	dev_info(&pdev->dev, "Broadcom UniMAC MDIO bus at 0x%p\n", priv->base);
+	dev_info(&pdev->dev, "Broadcom UniMAC MDIO bus\n");
 
 	return 0;