net: stmmac: Fix a race in EEE enable callback

We are saving the status of EEE even before we try to enable it. This
leads to a race with XMIT function that tries to arm EEE timer before we
set it up.

Fix this by only saving the EEE parameters after all operations are
performed with success.

Signed-off-by: Jose Abreu <joabreu@synopsys.com>
Fixes: d765955d2a ("stmmac: add the Energy Efficient Ethernet support")
Cc: Joao Pinto <jpinto@synopsys.com>
Cc: David S. Miller <davem@davemloft.net>
Cc: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Cc: Alexandre Torgue <alexandre.torgue@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c

@@ -696,25 +696,27 @@ static int stmmac_ethtool_op_set_eee(struct net_device *dev,
 				     struct ethtool_eee *edata)
 {
 	struct stmmac_priv *priv = netdev_priv(dev);
+	int ret;
 
-	priv->eee_enabled = edata->eee_enabled;
-
-	if (!priv->eee_enabled)
+	if (!edata->eee_enabled) {
 		stmmac_disable_eee_mode(priv);
-	else {
+	} else {
 		/* We are asking for enabling the EEE but it is safe
 		 * to verify all by invoking the eee_init function.
 		 * In case of failure it will return an error.
 		 */
-		priv->eee_enabled = stmmac_eee_init(priv);
-		if (!priv->eee_enabled)
+		edata->eee_enabled = stmmac_eee_init(priv);
+		if (!edata->eee_enabled)
 			return -EOPNOTSUPP;
-
-		/* Do not change tx_lpi_timer in case of failure */
-		priv->tx_lpi_timer = edata->tx_lpi_timer;
 	}
 
-	return phy_ethtool_set_eee(dev->phydev, edata);
+	ret = phy_ethtool_set_eee(dev->phydev, edata);
+	if (ret)
+		return ret;
+
+	priv->eee_enabled = edata->eee_enabled;
+	priv->tx_lpi_timer = edata->tx_lpi_timer;
+	return 0;
 }
 
 static u32 stmmac_usec2riwt(u32 usec, struct stmmac_priv *priv)