ACPI fixes for 5.0-rc2

- Fix build failures with both CONFIG_NLS and CONFIG_PCI unset that
    can occur since ACPI can be built without PCI now (Sinan Kaya).
 
  - Clean up the handling of duplicate entries in power resource lists
    returned by _PRx evaluation to avoid triggering WARN_ON() on
    attempts to add duplicate symlinks in sysfs (Hans de Goede).
 
  - Fix issues with the TS current-source switching on systems using
    the xpower PMIC by avoiding to update unrelated bits in the TS
    pin-ctrl register and avoiding to unconditionally enable TS
    current-source on systems where it is not used (Hans de Goede).
 
  - Fix addresses in NUMA-related messages on 32-bit with PAE which
    can be truncated due to integer type conversions (Chao Fan).
 -----BEGIN PGP SIGNATURE-----
 Version: GnuPG v2
 
 iQIcBAABCAAGBQJcOGwhAAoJEILEb/54YlRx2f8QAJZlOPuSlzXO5pl2ki8L/XXW
 S0vj6zOjR0mUeWuvq4ipKE/FzF7GZi+WjbMbJCF3C/txoHaYZqoGLjM0XZmiACi5
 4FrFEDyVfLZRoXfM0z9XcoptG9jWdBuGT8DckwnkeOdgxusop9kpIaDv8QDOLCXz
 +nZjPeG8wkGH+shNSyHb0q+Jok1Q2rNLHdkjzFkjjso803ORhVah7LcQkAViYPab
 L3r39MzuEpemRuPvLNzntWrNlKZyDZna8ydDD2PR1aqK8X2vIwT+Noo/WmismMWk
 wW4/GRL3DR5gnsmf/qpyQHnSKMvZLi6/JTe6etXTURKuZ6KtCxFsdjH7Ygaa65J9
 CL5C7Y3x0C8gJk4c9UP9jnVUY3IFm+R3xyynQWAnRLg7+kobN7h4lYyL12nwhWBS
 +vfVfaheHETNTx8K6agLbYzgcY6iNbZw0DeZM4oIAL+jRXyvhIjHjjGMnUPG1sTf
 K1EL2BtBL5virZJWgLv//87SKGxN39pBkR/zyx7rFKRY7mFztmLaQoEvpFP4HEv1
 ge1PhFU+8hPSzj3rElfOwZi5W7DRETpKnaNtRBNDRQnFSeWuCiKjAfLHVFND0EjH
 0sHk4Rjx5H6iDyMCoWyc3H4Dcdz89fwvH+ByAWlW+L1locJFrNEKoQgSeP9CAk7f
 srtuj+V+QtsVIaxBWhP6
 =83Yo
 -----END PGP SIGNATURE-----

Merge tag 'acpi-5.0-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/rafael/linux-pm

Pull ACPI fixes from Rafael Wysocki:
 "Fix a build failure introduced recently, fix the xpower PMIC ACPI
  driver, clean up the handling of duplicate entries in _PRx power
  resource lists and fix addresses in NUMA-related messages on 32-bit
  with PAE.

  Specifics:

   - Fix build failures with both CONFIG_NLS and CONFIG_PCI unset that
     can occur since ACPI can be built without PCI now (Sinan Kaya).

   - Clean up the handling of duplicate entries in power resource lists
     returned by _PRx evaluation to avoid triggering WARN_ON() on
     attempts to add duplicate symlinks in sysfs (Hans de Goede).

   - Fix issues with the TS current-source switching on systems using
     the xpower PMIC by avoiding to update unrelated bits in the TS
     pin-ctrl register and avoiding to unconditionally enable TS
     current-source on systems where it is not used (Hans de Goede).

   - Fix addresses in NUMA-related messages on 32-bit with PAE which can
     be truncated due to integer type conversions (Chao Fan)"

* tag 'acpi-5.0-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/rafael/linux-pm:
  ACPI / PMIC: xpower: Fix TS-pin current-source handling
  ACPI: NUMA: Use correct type for printing addresses on i386-PAE
  ACPI: power: Skip duplicate power resource references in _PRx
  ACPI: Fix build failure when CONFIG_NLS is set to 'n'

drivers/acpi/Kconfig

@@ -10,6 +10,7 @@ menuconfig ACPI
 	bool "ACPI (Advanced Configuration and Power Interface) Support"
 	depends on ARCH_SUPPORTS_ACPI
 	select PNP
+	select NLS
 	default y if X86
 	help
 	  Advanced Configuration and Power Interface (ACPI) support for 

drivers/acpi/numa.c

@@ -146,9 +146,9 @@ acpi_table_print_srat_entry(struct acpi_subtable_header *header)
 		{
 			struct acpi_srat_mem_affinity *p =
 			    (struct acpi_srat_mem_affinity *)header;
-			pr_debug("SRAT Memory (0x%lx length 0x%lx) in proximity domain %d %s%s%s\n",
-				 (unsigned long)p->base_address,
-				 (unsigned long)p->length,
+			pr_debug("SRAT Memory (0x%llx length 0x%llx) in proximity domain %d %s%s%s\n",
+				 (unsigned long long)p->base_address,
+				 (unsigned long long)p->length,
 				 p->proximity_domain,
 				 (p->flags & ACPI_SRAT_MEM_ENABLED) ?
 				 "enabled" : "disabled",

drivers/acpi/pmic/intel_pmic_xpower.c

@@ -20,8 +20,11 @@
 #define GPI1_LDO_ON		(3 << 0)
 #define GPI1_LDO_OFF		(4 << 0)
 
-#define AXP288_ADC_TS_PIN_GPADC	0xf2
-#define AXP288_ADC_TS_PIN_ON	0xf3
+#define AXP288_ADC_TS_CURRENT_ON_OFF_MASK		GENMASK(1, 0)
+#define AXP288_ADC_TS_CURRENT_OFF			(0 << 0)
+#define AXP288_ADC_TS_CURRENT_ON_WHEN_CHARGING		(1 << 0)
+#define AXP288_ADC_TS_CURRENT_ON_ONDEMAND		(2 << 0)
+#define AXP288_ADC_TS_CURRENT_ON			(3 << 0)
 
 static struct pmic_table power_table[] = {
 	{
@@ -212,22 +215,44 @@ out:
  */
 static int intel_xpower_pmic_get_raw_temp(struct regmap *regmap, int reg)
 {
+	int ret, adc_ts_pin_ctrl;
 	u8 buf[2];
-	int ret;
 
-	ret = regmap_write(regmap, AXP288_ADC_TS_PIN_CTRL,
-			   AXP288_ADC_TS_PIN_GPADC);
+	/*
+	 * The current-source used for the battery temp-sensor (TS) is shared
+	 * with the GPADC. For proper fuel-gauge and charger operation the TS
+	 * current-source needs to be permanently on. But to read the GPADC we
+	 * need to temporary switch the TS current-source to ondemand, so that
+	 * the GPADC can use it, otherwise we will always read an all 0 value.
+	 *
+	 * Note that the switching from on to on-ondemand is not necessary
+	 * when the TS current-source is off (this happens on devices which
+	 * do not use the TS-pin).
+	 */
+	ret = regmap_read(regmap, AXP288_ADC_TS_PIN_CTRL, &adc_ts_pin_ctrl);
 	if (ret)
 		return ret;
 
-	/* After switching to the GPADC pin give things some time to settle */
-	usleep_range(6000, 10000);
+	if (adc_ts_pin_ctrl & AXP288_ADC_TS_CURRENT_ON_OFF_MASK) {
+		ret = regmap_update_bits(regmap, AXP288_ADC_TS_PIN_CTRL,
+					 AXP288_ADC_TS_CURRENT_ON_OFF_MASK,
+					 AXP288_ADC_TS_CURRENT_ON_ONDEMAND);
+		if (ret)
+			return ret;
+
+		/* Wait a bit after switching the current-source */
+		usleep_range(6000, 10000);
+	}
 
 	ret = regmap_bulk_read(regmap, AXP288_GP_ADC_H, buf, 2);
 	if (ret == 0)
 		ret = (buf[0] << 4) + ((buf[1] >> 4) & 0x0f);
 
-	regmap_write(regmap, AXP288_ADC_TS_PIN_CTRL, AXP288_ADC_TS_PIN_ON);
+	if (adc_ts_pin_ctrl & AXP288_ADC_TS_CURRENT_ON_OFF_MASK) {
+		regmap_update_bits(regmap, AXP288_ADC_TS_PIN_CTRL,
+				   AXP288_ADC_TS_CURRENT_ON_OFF_MASK,
+				   AXP288_ADC_TS_CURRENT_ON);
+	}
 
 	return ret;
 }

drivers/acpi/power.c

@@ -131,6 +131,23 @@ void acpi_power_resources_list_free(struct list_head *list)
 	}
 }
 
+static bool acpi_power_resource_is_dup(union acpi_object *package,
+				       unsigned int start, unsigned int i)
+{
+	acpi_handle rhandle, dup;
+	unsigned int j;
+
+	/* The caller is expected to check the package element types */
+	rhandle = package->package.elements[i].reference.handle;
+	for (j = start; j < i; j++) {
+		dup = package->package.elements[j].reference.handle;
+		if (dup == rhandle)
+			return true;
+	}
+
+	return false;
+}
+
 int acpi_extract_power_resources(union acpi_object *package, unsigned int start,
 				 struct list_head *list)
 {
@@ -150,6 +167,11 @@ int acpi_extract_power_resources(union acpi_object *package, unsigned int start,
 			err = -ENODEV;
 			break;
 		}
+
+		/* Some ACPI tables contain duplicate power resource references */
+		if (acpi_power_resource_is_dup(package, start, i))
+			continue;
+
 		err = acpi_add_power_resource(rhandle);
 		if (err)
 			break;