scsi: megaraid_sas: Fix msleep granularity

In megasas_transition_to_ready() driver waits 180seconds for controller to
change FW state. Here we are calling msleep(1) in a loop for this.  As
explained in timers-howto.txt, msleep(1) will actually sleep longer than
1ms. If a faulty controller is connected, we will end up waiting for much
more than 180 seconds causing unnecessary delays during load.

Change the granularity of msleep() call from 1ms to 1000ms.

Signed-off-by: Shivasharan S <shivasharan.srikanteshwara@broadcom.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/megaraid/megaraid_sas_base.c

@@ -3891,12 +3891,12 @@ megasas_transition_to_ready(struct megasas_instance *instance, int ocr)
 		/*
 		 * The cur_state should not last for more than max_wait secs
 		 */
-		for (i = 0; i < (max_wait * 1000); i++) {
+		for (i = 0; i < max_wait; i++) {
 			curr_abs_state = instance->instancet->
 				read_fw_status_reg(instance->reg_set);
 
 			if (abs_state == curr_abs_state) {
-				msleep(1);
+				msleep(1000);
 			} else
 				break;
 		}