staging: wfx: apply the necessary SDIO quirks for the Silabs WF200

Until now, the SDIO quirks are applied directly from the driver.
However, it is better to apply the quirks before driver probing. So,
this patch relocate the quirks in the MMC framework.

Note that the WF200 has no valid SDIO VID/PID. Therefore, we match DT
rather than on the SDIO VID/PID.

Reviewed-by: Pali Rohár <pali@kernel.org>
Reviewed-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Jérôme Pouiller <jerome.pouiller@silabs.com>
Link: https://lore.kernel.org/r/20220216093112.92469-3-Jerome.Pouiller@silabs.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/mmc/core/quirks.h

@@ -149,6 +149,11 @@ static const struct mmc_fixup __maybe_unused sdio_fixup_methods[] = {
 static const struct mmc_fixup __maybe_unused sdio_card_init_methods[] = {
 	SDIO_FIXUP_COMPATIBLE("ti,wl1251", wl1251_quirk, 0),
 
+	SDIO_FIXUP_COMPATIBLE("silabs,wf200", add_quirk,
+			      MMC_QUIRK_BROKEN_BYTE_MODE_512 |
+			      MMC_QUIRK_LENIENT_FN0 |
+			      MMC_QUIRK_BLKSZ_FOR_BYTE_MODE),
+
 	END_FIXUP
 };
 

drivers/staging/wfx/bus_sdio.c

@@ -216,9 +216,6 @@ static int wfx_sdio_probe(struct sdio_func *func, const struct sdio_device_id *i
 	bus->func = func;
 	bus->of_irq = irq_of_parse_and_map(np, 0);
 	sdio_set_drvdata(func, bus);
-	func->card->quirks |= MMC_QUIRK_LENIENT_FN0 |
-			      MMC_QUIRK_BLKSZ_FOR_BYTE_MODE |
-			      MMC_QUIRK_BROKEN_BYTE_MODE_512;
 
 	sdio_claim_host(func);
 	ret = sdio_enable_func(func);