mtd: rawnand: marvell: Clean the controller state before each operation

Since the migration of the driver to stop using the legacy
->select_chip() hook, there is nothing deselecting the target anymore,
thus the selection is not forced at the next access. Ensure the ND_RUN
bit and the interrupts are always in a clean state.

Cc: Daniel Mack <daniel@zonque.org>
Cc: stable@vger.kernel.org
Fixes: b25251414f ("mtd: rawnand: marvell: Stop implementing ->select_chip()")
Suggested-by: Boris Brezillon <boris.brezillon@collabora.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Tested-by: Daniel Mack <daniel@zonque.org>
Reviewed-by: Boris Brezillon <boris.brezillon@collabora.com>
Signed-off-by: Richard Weinberger <richard@nod.at>

drivers/mtd/nand/raw/marvell_nand.c

@@ -722,12 +722,6 @@ static void marvell_nfc_select_target(struct nand_chip *chip,
 	struct marvell_nfc *nfc = to_marvell_nfc(chip->controller);
 	u32 ndcr_generic;
 
-	if (chip == nfc->selected_chip && die_nr == marvell_nand->selected_die)
-		return;
-
-	writel_relaxed(marvell_nand->ndtr0, nfc->regs + NDTR0);
-	writel_relaxed(marvell_nand->ndtr1, nfc->regs + NDTR1);
-
 	/*
 	 * Reset the NDCR register to a clean state for this particular chip,
 	 * also clear ND_RUN bit.
@@ -739,6 +733,12 @@ static void marvell_nfc_select_target(struct nand_chip *chip,
 	/* Also reset the interrupt status register */
 	marvell_nfc_clear_int(nfc, NDCR_ALL_INT);
 
+	if (chip == nfc->selected_chip && die_nr == marvell_nand->selected_die)
+		return;
+
+	writel_relaxed(marvell_nand->ndtr0, nfc->regs + NDTR0);
+	writel_relaxed(marvell_nand->ndtr1, nfc->regs + NDTR1);
+
 	nfc->selected_chip = chip;
 	marvell_nand->selected_die = die_nr;
 }