arm64: unify idmap removal
We currently open-code the removal of the idmap and restoration of the current task's MMU state in a few places. Before introducing yet more copies of this sequence, unify these to call a new helper, cpu_uninstall_idmap. Signed-off-by: Mark Rutland <mark.rutland@arm.com> Reviewed-by: Catalin Marinas <catalin.marinas@arm.com> Tested-by: Ard Biesheuvel <ard.biesheuvel@linaro.org> Reviewed-by: Ard Biesheuvel <ard.biesheuvel@linaro.org> Tested-by: Jeremy Linton <jeremy.linton@arm.com> Cc: Laura Abbott <labbott@fedoraproject.org> Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com> Cc: Will Deacon <will.deacon@arm.com> Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
This commit is contained in:
Родитель
5227cfa71f
Коммит
9e8e865bbe
|
@ -27,6 +27,7 @@
|
|||
#include <asm-generic/mm_hooks.h>
|
||||
#include <asm/cputype.h>
|
||||
#include <asm/pgtable.h>
|
||||
#include <asm/tlbflush.h>
|
||||
|
||||
#ifdef CONFIG_PID_IN_CONTEXTIDR
|
||||
static inline void contextidr_thread_switch(struct task_struct *next)
|
||||
|
@ -89,6 +90,30 @@ static inline void cpu_set_default_tcr_t0sz(void)
|
|||
: "r"(TCR_T0SZ(VA_BITS)), "I"(TCR_T0SZ_OFFSET), "I"(TCR_TxSZ_WIDTH));
|
||||
}
|
||||
|
||||
/*
|
||||
* Remove the idmap from TTBR0_EL1 and install the pgd of the active mm.
|
||||
*
|
||||
* The idmap lives in the same VA range as userspace, but uses global entries
|
||||
* and may use a different TCR_EL1.T0SZ. To avoid issues resulting from
|
||||
* speculative TLB fetches, we must temporarily install the reserved page
|
||||
* tables while we invalidate the TLBs and set up the correct TCR_EL1.T0SZ.
|
||||
*
|
||||
* If current is a not a user task, the mm covers the TTBR1_EL1 page tables,
|
||||
* which should not be installed in TTBR0_EL1. In this case we can leave the
|
||||
* reserved page tables in place.
|
||||
*/
|
||||
static inline void cpu_uninstall_idmap(void)
|
||||
{
|
||||
struct mm_struct *mm = current->active_mm;
|
||||
|
||||
cpu_set_reserved_ttbr0();
|
||||
local_flush_tlb_all();
|
||||
cpu_set_default_tcr_t0sz();
|
||||
|
||||
if (mm != &init_mm)
|
||||
cpu_switch_mm(mm->pgd, mm);
|
||||
}
|
||||
|
||||
/*
|
||||
* It would be nice to return ASIDs back to the allocator, but unfortunately
|
||||
* that introduces a race with a generation rollover where we could erroneously
|
||||
|
|
|
@ -62,6 +62,7 @@
|
|||
#include <asm/memblock.h>
|
||||
#include <asm/efi.h>
|
||||
#include <asm/xen/hypervisor.h>
|
||||
#include <asm/mmu_context.h>
|
||||
|
||||
phys_addr_t __fdt_pointer __initdata;
|
||||
|
||||
|
|
|
@ -149,9 +149,7 @@ asmlinkage void secondary_start_kernel(void)
|
|||
* TTBR0 is only used for the identity mapping at this stage. Make it
|
||||
* point to zero page to avoid speculatively fetching new entries.
|
||||
*/
|
||||
cpu_set_reserved_ttbr0();
|
||||
local_flush_tlb_all();
|
||||
cpu_set_default_tcr_t0sz();
|
||||
cpu_uninstall_idmap();
|
||||
|
||||
preempt_disable();
|
||||
trace_hardirqs_off();
|
||||
|
|
|
@ -60,7 +60,6 @@ void __init cpu_suspend_set_dbg_restorer(void (*hw_bp_restore)(void *))
|
|||
*/
|
||||
int cpu_suspend(unsigned long arg, int (*fn)(unsigned long))
|
||||
{
|
||||
struct mm_struct *mm = current->active_mm;
|
||||
int ret;
|
||||
unsigned long flags;
|
||||
|
||||
|
@ -87,22 +86,11 @@ int cpu_suspend(unsigned long arg, int (*fn)(unsigned long))
|
|||
ret = __cpu_suspend_enter(arg, fn);
|
||||
if (ret == 0) {
|
||||
/*
|
||||
* We are resuming from reset with TTBR0_EL1 set to the
|
||||
* idmap to enable the MMU; set the TTBR0 to the reserved
|
||||
* page tables to prevent speculative TLB allocations, flush
|
||||
* the local tlb and set the default tcr_el1.t0sz so that
|
||||
* the TTBR0 address space set-up is properly restored.
|
||||
* If the current active_mm != &init_mm we entered cpu_suspend
|
||||
* with mappings in TTBR0 that must be restored, so we switch
|
||||
* them back to complete the address space configuration
|
||||
* restoration before returning.
|
||||
* We are resuming from reset with the idmap active in TTBR0_EL1.
|
||||
* We must uninstall the idmap and restore the expected MMU
|
||||
* state before we can possibly return to userspace.
|
||||
*/
|
||||
cpu_set_reserved_ttbr0();
|
||||
local_flush_tlb_all();
|
||||
cpu_set_default_tcr_t0sz();
|
||||
|
||||
if (mm != &init_mm)
|
||||
cpu_switch_mm(mm->pgd, mm);
|
||||
cpu_uninstall_idmap();
|
||||
|
||||
/*
|
||||
* Restore per-cpu offset before any kernel
|
||||
|
|
|
@ -468,9 +468,7 @@ void __init paging_init(void)
|
|||
* TTBR0 is only used for the identity mapping at this stage. Make it
|
||||
* point to zero page to avoid speculatively fetching new entries.
|
||||
*/
|
||||
cpu_set_reserved_ttbr0();
|
||||
local_flush_tlb_all();
|
||||
cpu_set_default_tcr_t0sz();
|
||||
cpu_uninstall_idmap();
|
||||
}
|
||||
|
||||
/*
|
||||
|
|
Загрузка…
Ссылка в новой задаче