Documentation: arm64: correct spelling

Correct spelling problems for Documentation/arm64/ as reported
by codespell.

Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Cc: Will Deacon <will@kernel.org>
Cc: linux-arm-kernel@lists.infradead.org
Cc: Jonathan Corbet <corbet@lwn.net>
Cc: linux-doc@vger.kernel.org
Reviewed-by: Mukesh Ojha <quic_mojha@quicinc.com>
Link: https://lore.kernel.org/r/20230127064005.1558-3-rdunlap@infradead.org
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>

Documentation/arm64/booting.rst

@@ -223,7 +223,7 @@ Before jumping into the kernel, the following conditions must be met:
   For systems with a GICv3 interrupt controller to be used in v3 mode:
   - If EL3 is present:
 
-      - ICC_SRE_EL3.Enable (bit 3) must be initialiased to 0b1.
+      - ICC_SRE_EL3.Enable (bit 3) must be initialised to 0b1.
       - ICC_SRE_EL3.SRE (bit 0) must be initialised to 0b1.
       - ICC_CTLR_EL3.PMHE (bit 6) must be set to the same value across
         all CPUs the kernel is executing on, and must stay constant

Documentation/arm64/elf_hwcaps.rst

@@ -14,7 +14,7 @@ Some hardware or software features are only available on some CPU
 implementations, and/or with certain kernel configurations, but have no
 architected discovery mechanism available to userspace code at EL0. The
 kernel exposes the presence of these features to userspace through a set
-of flags called hwcaps, exposed in the auxilliary vector.
+of flags called hwcaps, exposed in the auxiliary vector.
 
 Userspace software can test for features by acquiring the AT_HWCAP or
 AT_HWCAP2 entry of the auxiliary vector, and testing whether the relevant

Documentation/arm64/sve.rst

@@ -175,7 +175,7 @@ the SVE instruction set architecture.
 When returning from a signal handler:
 
 * If there is no sve_context record in the signal frame, or if the record is
-  present but contains no register data as desribed in the previous section,
+  present but contains no register data as described in the previous section,
   then the SVE registers/bits become non-live and take unspecified values.
 
 * If sve_context is present in the signal frame and contains full register
@@ -223,7 +223,7 @@ prctl(PR_SVE_SET_VL, unsigned long arg)
 	    Defer the requested vector length change until the next execve()
 	    performed by this thread.
 
-	    The effect is equivalent to implicit exceution of the following
+	    The effect is equivalent to implicit execution of the following
 	    call immediately after the next execve() (if any) by the thread:
 
 		prctl(PR_SVE_SET_VL, arg & ~PR_SVE_SET_VL_ONEXEC)