PM: ACPI: Output correct message on target power state

Transitioned power state logged at the end of setting ACPI power.

However, D3cold won't be in the message because state can only be
D3hot at most.

Use target_state to corretly report when power state is D3cold.

Cc: All applicable <stable@vger.kernel.org>
Signed-off-by: Kai-Heng Feng <kai.heng.feng@canonical.com>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>

drivers/acpi/device_pm.c

@@ -273,13 +273,13 @@ int acpi_device_set_power(struct acpi_device *device, int state)
  end:
 	if (result) {
 		dev_warn(&device->dev, "Failed to change power state to %s\n",
-			 acpi_power_state_string(state));
+			 acpi_power_state_string(target_state));
 	} else {
 		device->power.state = target_state;
 		ACPI_DEBUG_PRINT((ACPI_DB_INFO,
 				  "Device [%s] transitioned to %s\n",
 				  device->pnp.bus_id,
-				  acpi_power_state_string(state)));
+				  acpi_power_state_string(target_state)));
 	}
 
 	return result;