wimax: Makefile, Kconfig and docbook linkage for the stack

This patch provides Makefile and KConfig for the WiMAX stack,
integrating them into the networking stack's Makefile, Kconfig and
doc-book templates.

Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
This commit is contained in:
Inaky Perez-Gonzalez 2008-12-23 16:18:24 -08:00 коммит произвёл Greg Kroah-Hartman
Родитель 617209ccf7
Коммит b0c83ae1de
5 изменённых файлов: 62 добавлений и 0 удалений

Просмотреть файл

@ -74,6 +74,14 @@
!Enet/sunrpc/rpcb_clnt.c
!Enet/sunrpc/clnt.c
</sect1>
<sect1><title>WiMAX</title>
!Enet/wimax/op-msg.c
!Enet/wimax/op-reset.c
!Enet/wimax/op-rfkill.c
!Enet/wimax/stack.c
!Iinclude/net/wimax.h
!Iinclude/linux/wimax.h
</sect1>
</chapter>
<chapter id="netdev">

Просмотреть файл

@ -254,6 +254,8 @@ source "net/mac80211/Kconfig"
endif # WIRELESS
source "net/wimax/Kconfig"
source "net/rfkill/Kconfig"
source "net/9p/Kconfig"

Просмотреть файл

@ -63,3 +63,4 @@ endif
ifeq ($(CONFIG_NET),y)
obj-$(CONFIG_SYSCTL) += sysctl_net.o
endif
obj-$(CONFIG_WIMAX) += wimax/

38
net/wimax/Kconfig Normal file
Просмотреть файл

@ -0,0 +1,38 @@
#
# WiMAX LAN device configuration
#
menuconfig WIMAX
tristate "WiMAX Wireless Broadband support"
help
Select to configure support for devices that provide
wireless broadband connectivity using the WiMAX protocol
(IEEE 802.16).
Please note that most of these devices require signing up
for a service plan with a provider.
The different WiMAX drivers can be enabled in the menu entry
Device Drivers > Network device support > WiMAX Wireless
Broadband devices
If unsure, it is safe to select M (module).
config WIMAX_DEBUG_LEVEL
int "WiMAX debug level"
depends on WIMAX
default 8
help
Select the maximum debug verbosity level to be compiled into
the WiMAX stack code.
By default, debug messages are disabled at runtime and can
be selectively enabled for different parts of the code using
the sysfs debug-levels file.
If set at zero, this will compile out all the debug code.
It is recommended that it is left at 8.

13
net/wimax/Makefile Normal file
Просмотреть файл

@ -0,0 +1,13 @@
obj-$(CONFIG_WIMAX) += wimax.o
wimax-y := \
id-table.o \
op-msg.o \
op-reset.o \
op-rfkill.o \
stack.o
wimax-$(CONFIG_DEBUG_FS) += debugfs.o