r8152: remove sram_read

Read OCP register 0xa43a~0xa43b would clear some flags which the hw
would use, and it may let the device lost. However, the unit of
reading is 4 bytes. That is, it would read 0xa438~0xa43b when calling
sram_read() to read OCP_SRAM_DATA.

Signed-off-by: Hayes Wang <hayeswang@realtek.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/usb/r8152.c

@@ -920,12 +920,6 @@ static void sram_write(struct r8152 *tp, u16 addr, u16 data)
 	ocp_reg_write(tp, OCP_SRAM_DATA, data);
 }
 
-static u16 sram_read(struct r8152 *tp, u16 addr)
-{
-	ocp_reg_write(tp, OCP_SRAM_ADDR, addr);
-	return ocp_reg_read(tp, OCP_SRAM_DATA);
-}
-
 static int read_mii_word(struct net_device *netdev, int phy_id, int reg)
 {
 	struct r8152 *tp = netdev_priv(netdev);
@@ -2512,24 +2506,18 @@ static void r8153_hw_phy_cfg(struct r8152 *tp)
 	data = ocp_reg_read(tp, OCP_POWER_CFG);
 	data |= EN_10M_PLLOFF;
 	ocp_reg_write(tp, OCP_POWER_CFG, data);
-	data = sram_read(tp, SRAM_IMPEDANCE);
+	sram_write(tp, SRAM_IMPEDANCE, 0x0b13);
-	data &= ~RX_DRIVING_MASK;
-	sram_write(tp, SRAM_IMPEDANCE, data);
 
 	ocp_data = ocp_read_word(tp, MCU_TYPE_PLA, PLA_PHY_PWR);
 	ocp_data |= PFM_PWM_SWITCH;
 	ocp_write_word(tp, MCU_TYPE_PLA, PLA_PHY_PWR, ocp_data);
 
-	data = sram_read(tp, SRAM_LPF_CFG);
+	/* Enable LPF corner auto tune */
-	data |= LPF_AUTO_TUNE;
+	sram_write(tp, SRAM_LPF_CFG, 0xf70f);
-	sram_write(tp, SRAM_LPF_CFG, data);
 
-	data = sram_read(tp, SRAM_10M_AMP1);
+	/* Adjust 10M Amplitude */
-	data |= GDAC_IB_UPALL;
+	sram_write(tp, SRAM_10M_AMP1, 0x00af);
-	sram_write(tp, SRAM_10M_AMP1, data);
+	sram_write(tp, SRAM_10M_AMP2, 0x0208);
-	data = sram_read(tp, SRAM_10M_AMP2);
-	data |= AMP_DN;
-	sram_write(tp, SRAM_10M_AMP2, data);
 
 	set_bit(PHY_RESET, &tp->flags);
 }