dt-bindings: iio: adc: Add docs for AD7768-1
Document support for AD7768-1 Analog to Digital Converter. Signed-off-by: Stefan Popa <stefan.popa@analog.com> Reviewed-by: Rob Herring <robh@kernel.org> Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
This commit is contained in:
Родитель
a5f8c7da3d
Коммит
b64d973008
|
@ -0,0 +1,41 @@
|
|||
Analog Devices AD7768-1 ADC device driver
|
||||
|
||||
Required properties for the AD7768-1:
|
||||
|
||||
- compatible: Must be "adi,ad7768-1"
|
||||
- reg: SPI chip select number for the device
|
||||
- spi-max-frequency: Max SPI frequency to use
|
||||
see: Documentation/devicetree/bindings/spi/spi-bus.txt
|
||||
- clocks: phandle to the master clock (mclk)
|
||||
see: Documentation/devicetree/bindings/clock/clock-bindings.txt
|
||||
- clock-names: Must be "mclk".
|
||||
- interrupts: IRQ line for the ADC
|
||||
see: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
|
||||
- vref-supply: vref supply can be used as reference for conversion
|
||||
- adi,sync-in-gpios: must be the device tree identifier of the SYNC-IN pin. Enables
|
||||
synchronization of multiple devices that require simultaneous sampling.
|
||||
A pulse is always required if the configuration is changed in any way, for example
|
||||
if the filter decimation rate changes. As the line is active low, it should
|
||||
be marked GPIO_ACTIVE_LOW.
|
||||
|
||||
Optional properties:
|
||||
|
||||
- reset-gpios : GPIO spec for the RESET pin. If specified, it will be asserted during
|
||||
driver probe. As the line is active low, it should be marked GPIO_ACTIVE_LOW.
|
||||
|
||||
Example:
|
||||
|
||||
adc@0 {
|
||||
compatible = "adi,ad7768-1";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <2000000>;
|
||||
spi-cpol;
|
||||
spi-cpha;
|
||||
vref-supply = <&adc_vref>;
|
||||
interrupts = <25 IRQ_TYPE_EDGE_RISING>;
|
||||
interrupt-parent = <&gpio>;
|
||||
adi,sync-in-gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
|
||||
reset-gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
|
||||
clocks = <&ad7768_mclk>;
|
||||
clock-names = "mclk";
|
||||
};
|
|
@ -868,6 +868,7 @@ L: linux-iio@vger.kernel.org
|
|||
W: http://ez.analog.com/community/linux-device-drivers
|
||||
S: Supported
|
||||
F: drivers/iio/adc/ad7768-1.c
|
||||
F: Documentation/devicetree/bindings/iio/adc/adi,ad7768-1.txt
|
||||
|
||||
ANALOG DEVICES INC AD9389B DRIVER
|
||||
M: Hans Verkuil <hans.verkuil@cisco.com>
|
||||
|
|
Загрузка…
Ссылка в новой задаче