HID: rmi: Check that the device is a RMI device in suspend and resume callbacks

Commit 0925636042 ("HID: rmi: Disable scanning if the device is not a wake
source") introduced a regression for devices which use hid-rmi to handle
composite USB devices. The suspend or resume callbacks are not checking
that the device is a RMI device before calling rmi_read or rmi_write.
This results in dereferencing uninitialized variables on non RMI devices. This
patch checks that the RMI_DEVICE flag is set before sending RMI commands to the
device.

Reported-by: Rodrigo Gomes <rodrigo.toste.gomes@gmail.com>
Signed-off-by: Andrew Duggan <aduggan@synaptics.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>

drivers/hid/hid-rmi.c

@@ -594,6 +594,9 @@ static int rmi_suspend(struct hid_device *hdev, pm_message_t message)
 	int ret;
 	u8 buf[RMI_F11_CTRL_REG_COUNT];
 
+	if (!(data->device_flags & RMI_DEVICE))
+		return 0;
+
 	ret = rmi_read_block(hdev, data->f11.control_base_addr, buf,
 				RMI_F11_CTRL_REG_COUNT);
 	if (ret)
@@ -613,6 +616,9 @@ static int rmi_post_reset(struct hid_device *hdev)
 	struct rmi_data *data = hid_get_drvdata(hdev);
 	int ret;
 
+	if (!(data->device_flags & RMI_DEVICE))
+		return 0;
+
 	ret = rmi_reset_attn_mode(hdev);
 	if (ret) {
 		hid_err(hdev, "can not set rmi mode\n");
@@ -640,6 +646,11 @@ static int rmi_post_reset(struct hid_device *hdev)
 
 static int rmi_post_resume(struct hid_device *hdev)
 {
+	struct rmi_data *data = hid_get_drvdata(hdev);
+
+	if (!(data->device_flags & RMI_DEVICE))
+		return 0;
+
 	return rmi_reset_attn_mode(hdev);
 }
 #endif /* CONFIG_PM */